JVC TH-A85, TH-A55 manual Changing the VFP setting

Advanced operations

Changing the VFP setting	4 Press Cursor //5 repeatedly to select
	a parameter you want to adjust.
The VFP (Video Fine Processor) function
enables you to adjust the picture character	Adjust gradually and confirm picture appearance results are as
according to the type of programming,	preferred.
picture tone or personal preference.	• GAMMA (–4 to +4):
NOTE		Controls brightness of neutral tints while maintaining
		brightness of dark and bright portions.
Before you start operation;	• BRIGHTNESS (–16 to +16):
• The VFP setting screen disappears if no operations are done for more		Controls screen brightness.
than about 10 seconds. If the setting screen disappears before you	•	CONTRAST (–16 to +16):
finish, start from step 1 again.		Controls screen contrast.
7 To select a VFP mode	•	SATURATION (–16 to +16):
		Controls screen color depth.
1 Press VFP during playback.
	•	TINT (–16 to +16):
		Controls screen tint.
The current VFP settings appear on the TV screen.
	• SHARPNESS (+0 to +3):
Example:When “NORMAL” is selected.
		Controls screen sharpness.
	• Y DELAY (–2 to +2):
		Controls screen color gap.
	5 Press ENTER.

2 Press Cursor 3/2 repeatedly to select the VFP mode.

Each time you press the button, the VFP mode changes as follows;

ONORMAL O CINEMA O USER 1 O USER 2 O (back to the beginning)

•NORMAL:Normally select this.

•CINEMA: Suitable for movies.

•USER 1 and USER 2:

You can adjust parameters that affect picture appearance and store settings. Go to step 3.

NOTE

•You cannot adjust the parameters of “NORMAL” and “CINEMA”. Press VFP to return to normal screen.

7To adjust picture appearance manually

VFP menu disappears and the following pop-up window appears on the TV screen.

6 Press Cursor //5repeatedly to change the setting.

7 Press ENTER.

The current VFP settings appear again.

8 Repeat steps 4 to 7 to adjust other parameters.

To return to the normal screen

Press VFP.

To activate your setting

Press VFP, then press Cursor 3/2repeatedly to select “USER 1” or “USER 2” that you have changed the parameters.

3 Press Cursor 3/2 repeatedly to select “USER 1” or “USER 2”.

42