Getting started | This page is for |
7Assembling the satellite speakers (TH-A85 only)
Each speaker (except the center speaker) has been divided into two parts for shipment. Before connecting the satellite speakers, first assemble them by following the procedure below.
Speaker section | Stand |
Before assembling —
•Prepare a Phillips screwdriver.
•Take care not to drop the stand while assembling; otherwise, it may cause damage to the floor or injury.
•Ensure enough space exists for assembly and installation.
•Spread a large, thick cloth on the floor where you assemble the speakers, so you can protect the floor and the speaker itself.
1 Connect the speaker connectors to the stand connectors.
•Be sure to connect the speaker connectors by matching their sizes.
Front
Speaker connectors
Front
Stand
Speaker section Rear
2 Join the stand to the speaker section.
Stand
Speaker section
3 Fix the stand to the speaker section.
• Be sure to tighten the screws firmly.
Speaker section
Stand
Screws (4) (supplied,
M4 x 25 mm)
Repeat the procedure from step 1 to assemble the other satellite speakers.
NOTE
•Use the speaker after assembly is fully and correctly done.
•It is recommended to place a cushion under the speaker section. You can tighten the screws easily by placing the speaker section horizontally.
Cushion (not supplied)
11