JVC LPT0923-001B manual Automatic Satellite Programme, Recording

48 EN TIMER RECORDING

Automatic Satellite Programme	DECODER connector.
	● Make sure the satellite receiver is connected to the unit’s L-2 IN/
Recording	● Programme the timer on the satellite receiver.
	● Slide the TV/CABLE/SAT/DVD switch to DVD.

This function allows you to automatically record a satellite				1 Press HDD or DVD to choose the recording deck.
programme which is timer-programmed on your external satellite				2 Set “L-2 SELECT” to “SAT VIDEO” or “SAT S-VIDEO”.
receiver. Connect a satellite receiver to the unit’s L-2 IN/
				( pg. 61)
DECODER connector and programme the timer on the satellite
				● Also refer to “IMPORTANT” on page 65.
receiver. The unit starts or stops recording by the signals input
				3 Press REC MODE repeatedly to set the recording mode.
from the satellite receiver. After recording, the unit’s power shuts
off automatically.				#
				4 Press and hold SAT for about 2 seconds to engage the
				Automatic Satellite Programme Recording mode. “SAT#” appears
ATTENTION:				on the front display panel.
● Be sure not to turn on the satellite receiver before the programme				NOTES:
is executed; otherwise, the unit will start recording when the
				● To disengage the Automatic Satellite Programme Recording mode,
satellite receiver’s power is turned on.
				press SAT#.
● If you have connected another appliance other than a satellite
				● If the unit’s power is off, it is not possible to engage the Automatic
receiver to the L-2 IN/DECODER connector, be sure not to engage
				Satellite Programme Recording mode.
the Automatic Satellite Programme Recording mode; otherwise,
				● In step 4, if “SAT#” blinks quickly on the front display panel even
the unit will start recording when the connected appliance’s power
				though your satellite receiver’s power is off, Automatic Satellite
is turned on.
				Programme Recording will not work properly with that satellite
● Automatic Satellite Programme Recording and timer-recording
				receiver*. If this is the case, perform “Manual Timer Programming”
cannot be done at the same time.
				( pg. 46) to timer-record a satellite programme.
			HDD DVD	* Some satellite receivers output signals even if the power is off.
				Automatic Satellite Programme Recording is not possible with those
				satellite receivers.
				● “SAT#” blinks on the front display panel while Automatic Satellite
				Programme Recording is in progress.
				● For timer programming of the satellite receiver, refer to the instruction
				manual of the satellite receiver.
				● Automatic Satellite Programme Recording is not possible if your
				satellite receiver does not have a timer.
				● Pressing the unit’s 1 button while Automatic Satellite Programme
		CABLE/SAT		Recording is in progress turns off the unit’s power and disengages
		TV	DVD	the Automatic Satellite Programme Recording mode.
				● If there are more than one satellite programmes you wish to record
	HDD	DVD		with Automatic Satellite Programme Recording, it is not possible to
				set different recording modes for each programme.
				● Depending on the type of satellite receiver, the unit may not record a
				slight portion of the beginning of the programme or may record

slightly longer than the actual length of the programme.

● If you engage the Automatic Satellite Programme Recording mode when the satellite receiver’s power is on, the unit will not start Automatic Satellite Programme Recording even though “SAT#” blinks on the front display panel. When the satellite receiver shuts off once and is turned back on again, the unit starts recording.

● You can also record a programme from your cable system in the same way if the system has a timer.

● Just Clock ( pg. 73) does not work when the Automatic Satellite Programme Recording mode is engaged.

REC MODE

SAT#