JVC LPT0923-001B manual Edit From a Camcorder, If the camcorder has no S-VIDEO output connector

EDITING EN 59

	Edit From A Camcorder	● Slide the TV/CABLE/SAT/DVD switch to DVD.
		1 Make connections.
You can use a camcorder as the source player and your unit as the
		A If the camcorder has no S-VIDEO output connector:
recording deck.
		— connect the camcorder’s AUDIO/VIDEO OUT connectors to the

A If the camcorder has no S-VIDEO output connector:	unit’s AUDIO/VIDEO input connectors on the front panel.
	● When using a monaural camcorder, connect its AUDIO OUT
AUDIO/VIDEO input	connector to the AUDIO L input connector on your unit.
	B If the camcorder has an S-VIDEO output connector:
	— connect the camcorder’s AUDIO OUT and S-VIDEO OUT
	connectors to the unit’s AUDIO and S-VIDEOinput connectors on
	the front panel.
Recorder	2 Press HDD or DVD repeatedly to select the recording deck.
	3 Press PR +/– to select “F-1”.
	● Set “F-1 INPUT” to “VIDEO” for the VIDEO input connector, or
	“S-VIDEO” for the S-VIDEO input connector, depending on the
	connector being used. ( pg. 62)

Audio/video cable (not provided)

AUDIO/VIDEO OUT

Player

BIf the camcorder has an S-VIDEO output connector:

S-VIDEO input

AUDIO input

4 Press REC MODE repeatedly to set the recording mode.

5 Start playback on the camcorder slightly before the actual point from where you wish to start dubbing.

6 Press 7 on the unit to start recording. Or press and hold 7 and press 4 on the remote control. The dubbing starts.

7 Press 8 on the unit, then stop playback on the camcorder.

NOTES:

●All necessary cables can be obtained from your dealer.

●Refer to the camcorder’s instruction manual for operating procedure.

●The quality of dubbed picture becomes poorer than that of the original.

Recorder

S-video cable (not provided)

S-VIDEO OUT
	Audio cable
AUDIO OUT	(not provided)

Player