JVC LPT0923-001B manual Connecting/Using a Decoder, Or An Amplifier With Built-in DTS

66 EN SYSTEM CONNECTIONS

Connecting To A Dolby Digital Decoder		When you can’t switch the audio channel of a bilingual
		programme
Or An Amplifier With Built-in DTS		When the unit is connected with a digital audio device using an
		optional optical cable and “DIGITAL AUDIO OUT” is set to “DOLBY
		DIGITAL/PCM”, it is not possible to switch the audio channel of a
These instructions enable you to connect your unit to a Dolby		bilingual programme recorded on a DVD-RAM or DVD-RW (VR
Digital decoder or an amplifier with built-in DTS.		mode) disc. In this case, perform the following steps using the
		remote control to switch “DIGITAL AUDIO OUT” from “DOLBY
		DIGITAL/PCM” to “PCM ONLY”. ( pg. 29)
		A Press SET UP to access the Main Menu screen.
		B Press w e to select “DVD VIDEO SET UP”, then press t.
		C Press w e to select “AUDIO OUTPUT”, then press t.
		D Press rt to select “DIGITAL AUDIO OUT”, then press
		ENTER.
		E Press rt to select “PCM ONLY”, then press ENTER.
		( pg. 67)
Dolby Digital Decoder or		F Press SET UP to complete the setting.
		G Press AUDIO to select the desired audio channel.
amplifier with built-in DTS
To DIGITAL AUDIO input		Connecting/Using A Decoder
Optical cable	Coaxial cable	The L-2 IN/DECODER connector can be used as an input
(not provided)	(not provided)	connector for an external decoder (descrambler). Simply connect a
		decoder and you can enjoy a variety of programming that is
		available through scrambled channels.

DIGITAL OUT (COAXIAL)

DIGITAL OUT (OPTICAL)

Note for connection:

Remove the protection cap from the cable.

Decoder

TV aerial cable

L-1 IN/OUT

L-2 IN/DECODER

TV

1 Connect the unit and a Dolby Digital decoder or an amplifier with built-in DTS using either an optional optical cable or an optional coaxial cable.

NOTES:

●For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY DIGITAL/PCM”. ( pg. 67)

●For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”. ( pg. 67)

CAUTIONS:

●This unit has a dynamic range of more than 110 dB with regards to its Hi-Fi audio capability. It is recommended that you check the maximum level if you are going to listen to the Hi-Fi audio signals through a stereo amplifier. A sudden surge in the input level to the speakers may damage them.

●Some speakers and televisions are specially shielded to prevent television interference. If both are of the non-shielded type, do not place the speakers adjacent to the TV set as this can adversely affect the playback picture.

RF cable (provided)

1Set “L-2 SELECT” to “DECODER”. ( pg. 61)

2Connect your unit’s L-2 IN/DECODER connector to the decoder’s 21-pin SCART connector using a 21-pin SCART cable.

3Perform the procedure as described in “When Receiving A Scrambled Broadcast” ( pg. 72).