JVC 1004MKH-VT-VT manual Switching the TV ON/OFF

Connections to the RF input socket

•Connect the aerial or cable TV plug to the RF input socket located at the back of the TV and connect the cable plug coming out from the TV out socket located at the devices (VCR, DVB etc.)79to￿5(this$5￿3$1(/socket as well&$%/(￿79. ￿

How to connect other devices

IMPORTANT: Switch off the TV before connect- ing any external device.

Sockets for external connections are at the back of the TV. For connection of other devices via Euroconnector refer to the manuals of the related devices.

Inserting batteries in the remote control handset

•Remove the battery cover located on the back of the handset by gently pulling upwards from the indicated part.

•Insert two AA/R6 dry cell or equivalent type of batteries inside.

•Replace the battery cover.

NOTE: Remove the batteries from remote con- trol handset when it is not to be used for a long period.Otherwise it can be damaged due to any leakage of battery.

Old batteries must be disposed in a desig- nated area. If performance of the remote con- trol reduces, replace the batteries with the cor- rect type. Do not combine a used, old battery or a new one or mixed battery types. Remove dead batteries immediately to prevent acid from leaking into the battery compartment.

Switching the TV ON/OFF

To switch the TV on

Your TV will switch on in two steps:

1- Connect the power supply cord to the sys- tem. Then the TV switches itself to stand- by mode and the power lamp becomes red located on the front of the TV.

2- To switch on the TV from stand-by mode either:

Press the “” button on the remote control or on the right side of the TV

or.

press a digit button on the remote control so that a programme number is selected,

or,

Press “P/Ch” buttons on the right side of the

TV or press “ ” or “ ” buttons on the remote control, so that last switched off programme is selected.

By either ways the TV will switch on and the power lamp will become green.

To switch the TV off

•Press the “” button on the remote control or on the right side of the TV, so the TV will switch to stand-by mode and the power lamp will become red.

NOTE: To switch the TV off completely remove the mains plug from the socket.

- 11 -