0%(1$&8
.
Picture Mode
Picture mode OSD is displayed when BLUE button is pressed. Picture mode can be changed to standard, soft, and bright.
Sleep Timer
Sleep Timer mode OSD is displayed when YELLOW button is pressed.
The Sleep Timer is used to turn the TV off after a defined period of time after selecting this item. The timer can be programmed between Off and 120 minutes in steps of 10 minutes. (OFF, 010, 020, 030, 040, ... , 120)
If sleep timer is activated, at the end of the selected the time, the TV goes automatically to
Mute Indicator
It is placed in the upper middle of the screen when enabled, and it stays there until it is dis- abled.
To cancel mute, there are two alternatives; the
first one is by pressing the "
" button, this volume is set to the preceding value, and the second one is increasing the volume level. By decreasing the volume level in mute state, mute will not be ignored, only the volume level will decrease.
No-Signal Detection (TV mode)
If no valid signal detected, it takes 5 minutes to switch to the
After a Remote Control command (if
nal Timer is active) the timer stops and if no signal detected again the timer is initialized to 5 minutes and starts 3 seconds later again to count down.
It is not valid in EXT modes.
No-Signal and Out Of Range Detection (PC mode)
In PC Mode,as no menu is displayed,in case that there is no PC input to the TV,it is dis- played an OSD message:
No input signal detected
then the power lamp turns to amber and PC will be in PC standby mode. Press AV button,
digit buttons or “
” / “
” buttonsto exit standby mode.
In PC Mode,as no menu is displayed,in case that there is no PC input to the TV, but the reso- lution and the vertical frequency is not sup- ported by the concept, it is displayed an OSD message:
Signal out of range
Volume Bar
It is displayed in the lower middle of the screen. When a volume command is received (press-
ing “
+” or “
EXT Modes
By pressing the “AV” button you can switch your TV to EXT modes (except being in Tele- text). Pressing this button will consecutively switch the TV in one of the optional EXT
In order to quit the EXT mode press any digit
buttons or “
” or “
”
Zoom Modes
Zoom mode can be changed by pressing Red button. You can change the screen size ac- cording to the picture aspect ratio. Select the optimum one from the following ZOOM modes.
- 21 -