Hitachi 55HDX61A important safety instructions Phones Jack

Page 10

FRONT PANEL CONTROLS

FIRST TIME USE

POWER button

Display Monitor “MAIN POWER” button

This power button is for the complete system, and must be turned ON/OFF manually. It is recommended to leave the “MAIN POWER” to ON condition (lights red) for stand-by mode.

 

 

The Main Power button is located on the Back

 

 

STANDBY(RED) ON(GREEN) MAIN POWER

side, under the label “MAIN POWER”.

 

 

AVC POWER button

The AVC power can be turned ON/OFF manually or by remote control. Turning on the AVC Power will only turn on the AVC box if the “MAIN POWER” of the display monitor is off.

POWER light indicator

To turn the monitor ON, press the main power switch located on the lower right side of the monitor. A red stand-by indicator lamp located on the lower right corner of the front bezel will illuminate. The PDP is now ready for remote on/off operation.

Indicating Lamp

Power Status

Operating

 

 

 

Off

Off

When the main power switch is set

 

 

OFF.

 

 

 

Lights Red

Off

When the main power switch on the display

 

(Stand-by)

monitor is ON, and the AVC Center is OFF.

 

 

 

Lights Green

On

Display monitor MAIN POWER is ON and

 

 

AVC Center power is ON.

 

 

 

Lights Orange

Off

Display monitor MAIN POWER is ON and

(Flashing)

(Power Saving)

and AVC Center power is ON, with no signal

 

 

input except antenna (no sync. signal).

 

 

 

REMOTE CONTROL sensor

Point your remote at this area when selecting channels, adjusting volume, etc.

FRONT INPUT JACKS (for VIDEO: 5)

Use these audio/video jacks for a quick hook-up from a camcorder or VCR to instantly view your favorite show or new recording. Press the INPUTS button then use the CURSOR PAD and the SELECT button on the remote control to select INPUT 5. If you have mono sound, insert the audio cable into the left audio jack.

PHONES JACK

Use this jack for your head-phones. The TV’s internal speakers can also be heard. Turn off the internal speakers (see page 60) if you wish to listen to the head-phones only.

LEARNING AV NET Sensor

Point your equipment’s remote control at this area while using the AV NET Learning Wizard.

NOTES: 1. Your HITACHI Plasma TV will appear to be turned OFF (lights orange) if there is no video input when VIDEO: 1, 2, 3, 4, 5, or RGB is selected. Check the Power Light to make sure the Display Monitor is turned off or in Stand-by mode (lights red) when not in use.

2.Remote Control can not turn ON/OFF the “MAIN POWER” of the display monitor.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Operating Guide for 55HDX61A Important Safety Instructions Do not OpenPrevention of Screen Burn Read before operating equipmentPublic Viewing of Copyrighted Material USE Time AccessoriesFirst Securing to a wall HOW to Setup Your NEW Hitachi Plasma TelevisionFirst Time USE AntennaBest HOW to SET UP Your NEW Hitachi Plasma TelevisionViewing Vertical ViewingHookup Cables USE Antenna Connections to Rear Panel JacksFirst Time Front Panel Controls Photo InputPhones Jack Rear Panel Jacks Monitor OUTRGB Analog Input Upgrade CardTo Power Swivel Connector RGB Audio InputCableCARD Slot Rear Panel of AVCConnecting Plasma Display Monitor to AVC BOX Connecting External Video SourcesConnecting a Monaural Audio Source to INPUT1~INPUT5 Before Operating External Video SourceConnecting a Stereo VCR or Stereo Laserdisc Player Connecting S-VIDEO VCR or Laserdisc Player Hdmi input DVI to Hdmi InputSee page 27 for tips on Rear Panel Connections Digital VCR D-VHS Connecting External AUDIO/VIDEO Devices Connecting External Audio AmplifierConnecting AV Network AV Network Setup Wizard Setup Procedure Using AV Network Device CodesTo select Internal Speakers Remote controlUse the Cursor Pads To choose AV Receiver Speakers to on or OFF, then press Select to setAUDIO/VIDEO Codes for AV Network not for remote control Rear Panel Connections Time USETips on Rear Panel Connections Remote Control Remote ControlHOW to USE the Remote To Control Your Plasma TV Ratio RGB Analog Input Aspect Display ModeAspect button 480P InputMenu button DAY/NIGHT buttonPICTURE-IN-PICTURE button Guide buttonRemote ControlAV NET button AV NET Learning Wizard Softkeys. If the device responds, then it is properly set up Select OKPhoto Input Ant B Ant a Inputs buttonIeee Jump Select this menu item to view the chosen picture numberSlideshow RotateWhen an IEEE1394 device is connected Info button When an S-VIDEOVideo Dash button Volume VOL WHEEL, Mute buttonChannel CH WHEEL/CHANNEL Selector buttons Last Channel LC buttonPICTURE-IN-PICTURE PIP POP Mode PICTURE-IN-PICTUREPress the Cursor PAD or to enable the sub-picture sound PIP buttonSurf Mode PICTURE-IN-PICTURE PIP Mode PICTURE-IN-PICTURESplit Mode PICTURE-IN-PICTURE NtscSplit Freeze Main FreezeStrobe Freeze Precoded Cable BOX buttons HOW to USE the Remote To Control Cable BOX FunctionsOperating the precoded function for your cable box Exclusive TV buttonsPRE-CODED SET-TOP-BOX/SATELLITE Receiver buttons Precoded DVD Buttons HOW to USE the Remote To Control DVD FunctionsOperating the precoded function for your DVD player These buttons transmit the chosen precoded DVD codesPrecoded VCR/PVR Buttons HOW to USE the Remote To Control VCR/PVR FunctionsThese buttons transmit the chosen precoded VCR/PVR codes Operating the precoded function for your Audio component HOW to USE the Remote To Control Additional Audio EquipmentPrecoded Audio Buttons Input Access Remote VCR Brand Audio Brand OSD On-Screen Display ON-SCREEN DisplayVideo Audio ForChannel Manager Locks Timers Setup Power Swivel Video Picture ModeDisplay Contrast Reset Video Settings Noise ReductionColor Decoding ON-SCREENColor Management White BalanceAudio Language Digital Output DRCAuto Aspect AspectAspect Vertical PositionAuto Channel Scan Channel ManagerSet The Antenna Press Cursor PAD To highlight Ant a or Ant BSignal Meter Channel ListLocks Movie Ratings TV Ratings Canadian Ratings Eng Canadian Ratings English TableProgramming is not suitable for children Canadian Ratings FrnCanadian Ratings French Table Programming restricted to adults ContainsTimers Set The ClockSet Sleep Timer Set Day/Night TimerSet Event Timer Please Set Clock FirstSet Timer Recording Setup Menu PreferenceMenu Background Image PowerScreen Saver Set The Inputs Screen DisplayPress Cursor PAD or Set Black Side Panel Set Closed Caption ChannelCableCARD Info This feature will select the source of the Monitor OutputSet Monitor Out Set AV ControlSet Stand-By Mode UpgradesPower Swivel Using the RGB Input RGB on Screen DisplayOperation No SYNC. Signal Invalid Scan Freq Aspect Setup Power Swivel Move SEL Sel Video Aspect Setup Power Swivel Contrast Color TemperatureInput BrightnessEnhancer ResetAspect Auto Adjust Using the RGBPosition Phase to factory preset, for current RGB format Clock PhaseHorizontal Clock Using RGB InputCare of Your Hitachi Plasma Display Your Remote Control Do notReception Problems Ignition NoiseUseful Info Symptoms ControlUseful Info Picture Image SpectrumPlug and Play Trademark AcknowledgmentAgency Regulatory Information Inputs OutputsHome Electronics Division Hitachi Way Chula Vista, CADigital Media Division TruBass AccessoriesIndex 22-25END User License Agreement for Hitachi DTV Software Or the Software102 103 QR64291
Top Page Image Contents