Hitachi 55HDX61A important safety instructions Accessories, USE Time, First

ACCESSORIES

Check to make sure you have the following accessories before disposing of the packing material.

REMOTE			BATTERIES	POWER CORD			MONITOR	IR MOUSE
CONTROL			“AA” Batteries			CONNECTION CABLE		CABLE
USE			3.
TIME	A/V NET		BATTERIES
			“AAA” Batteries
FIRST			4.		5.		6.	7.
			TTB55 Table Top Stand		Subwoofer Cable		Cleaning Cloth	Speaker Wires
			(optional)
		1.
SIMPLE
REMOTE
				8.		9.	10.	11.
		A/V NET
	CH +
VOL -	SELECT	VOL +	Wall Mount WM51
MUTE		FAV CH	(optional)
	CH -
	MENU	INPUTS
	EXIT
	POWER
		2.				12.

CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate ventilation for the electronics or proper support for the front glass panel. This plasma television product is designed for a maximum tilting angle of 45 degrees from vertical.

2.This TTB55 stand for use only with Hitachi 55HDX61A. Use with other apparatus is capable of resulting in instability causing possible injury. See important marking located on bottom of stand.

3.The plasma display wall mount unit WM51 is for use only with Hitachi model 55HDX61A.

1.	Remote Control Unit CLU-3843WL (P# HL02063).		6.	Monitor Connection Cable (P# EW07883).
2.	Simple Remote Control Unit CLU-122S (P# HLO1863).		7.	Two IR Mouse cables (P# EY01641).
3.	Two “AA” size, 1.5V batteries (P# FQ00021).		8.	55” Table Top Stand (TTB55) (P# QJ01442K).
4.	Two “AAA” size, 1.5V batteries (P# FQ00061).		9.	Sub Woofer Cable (P# VZ11701).
5.	Power Cord:		10. Cleaning Cloth (P# MS00931).
			11. Speaker wires (for monitor speakers).
	Plasma Monitor	EV01841
			12. Wall Mount (WM51) (P# QX00564).
	AVC	EV01841

REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT

1.Open the battery cover of the remote control by pushing the notched part of the cover with your fingers and pulling the cover off.

2.Insert two new “AA” and “AAA” size batteries for the remote control and Simple Remote Control respectively. When replacing old batteries, push them towards the springs and lift them out.

3.Match the batteries to the (+) and (-) marks in the battery compartment.

4.Replace the cover.

BOTTOM VIEW (Remote Control)

Press down and slide back to remove.

BOTTOM VIEW

(Simple Remote Control)

Lift up on tab to remove back cover.

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalent type.

4