Hitachi 55HDX61A Read before operating equipment, Prevention of Screen Burn

Page 3

IMPORTANT SAFETY INSTRUCTIONS

Read before operating equipment

Follow all warnings and instructions marked on this television.

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with a dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11.Only use the attachments/accessories specified by the manufacturer.

12.Use only with the cart, stand, tripod, bracket,

or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13.Unplug this apparatus during lightning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15.Televisions are designed to comply with the recommended safety standards for tilt and stability.

Do not apply excessive pulling force to the front, or top, of the cabinet which could cause the product to overturn resulting in product damage and/or personal injury.

16.Follow instructions for wall, shelf or ceiling mounting as recommended by the manufacturer.

17.An outdoor antenna should not be located in the vicinity of overhead power lines or other electrical circuits.

18.If an outside antenna is connected to the receiver be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges. Section 810 of the National Electric Code, ANSI/NFPA No. 70-1984, provides information with respect to proper grounding for the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding connectors, location of antenna-discharge unit, connection to grounding electrodes and requirements for the grounding electrode.

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿

￿￿￿￿￿￿

￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

Note to the CATV system installer: This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

This product contains lead. Dispose of this product in accordance with applicable environmental laws. For product recycling and disposal information, contact you local government agency or the Electronic Industries Alliance at www.eiae.org (in the US) or the Electronic Product Stewardship Canada at www.epsc.ca (in Canada). For more information, call “1-800-HITACHI.”

Do not place any objects on the top of the television which may fall or cause a child to climb to retrieve the objects.

PREVENTION OF SCREEN BURN

Continuous on-screen displays such as video games, stock market quotations, computer generated graphics, and other fixed (non- moving) patterns can cause permanent damage to television receivers. Such “SCREEN BURNS” constitute misuse and are NOT COVERED by your HITACHI Factory Warranty.

PUBLIC VIEWING OF COPYRIGHTED MATERIAL

Public viewing of programs broadcast by TV stations and cable companies, as well as programs from other sources, may require prior authorization from the broadcaster or owner of the video program material.

This digital television is capable of receiving analog basic, digital basic and digital premium cable television programming by direct con- nection to a cable system providing such programming. A CableCARD provided by your cable operator is required to view encrypted digital programming. Certain advanced and interactive digital cable services such as video-on-demand, a cable operator’s enhanced program guide and data-enhanced television services may require the use of a set-top box. For more information call your local cable company.

This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited consumer uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited.

3

Image 3
Contents Operating Guide for 55HDX61A Do not Open Important Safety InstructionsRead before operating equipment Prevention of Screen BurnPublic Viewing of Copyrighted Material Accessories USE TimeFirst Antenna HOW to Setup Your NEW Hitachi Plasma TelevisionFirst Time USE Securing to a wallVertical Viewing HOW to SET UP Your NEW Hitachi Plasma TelevisionViewing BestHookup Cables Antenna Connections to Rear Panel Jacks USEFirst Time Photo Input Front Panel ControlsPhones Jack Monitor OUT Rear Panel JacksRGB Audio Input Upgrade CardTo Power Swivel Connector RGB Analog InputRear Panel of AVC CableCARD SlotConnecting External Video Sources Connecting Plasma Display Monitor to AVC BOXBefore Operating External Video Source Connecting a Monaural Audio Source to INPUT1~INPUT5Connecting a Stereo VCR or Stereo Laserdisc Player Connecting S-VIDEO VCR or Laserdisc Player DVI to Hdmi Input Hdmi inputSee page 27 for tips on Rear Panel Connections Digital VCR D-VHS Connecting External Audio Amplifier Connecting External AUDIO/VIDEO DevicesConnecting AV Network Setup Procedure Using AV Network Device Codes AV Network Setup WizardSpeakers to on or OFF, then press Select to set Remote controlUse the Cursor Pads To choose AV Receiver To select Internal SpeakersAUDIO/VIDEO Codes for AV Network not for remote control Time USE Rear Panel ConnectionsTips on Rear Panel Connections Remote Control Remote ControlHOW to USE the Remote To Control Your Plasma TV 480P Input RGB Analog Input Aspect Display ModeAspect button RatioGuide button DAY/NIGHT buttonPICTURE-IN-PICTURE button Menu buttonControl RemoteAV NET button AV NET Learning Wizard Select OK Softkeys. If the device responds, then it is properly set upInputs button Photo Input Ant B Ant aIeee Select this menu item to view the chosen picture number JumpRotate SlideshowWhen an IEEE1394 device is connected When an S-VIDEO Info buttonVideo Last Channel LC button Volume VOL WHEEL, Mute buttonChannel CH WHEEL/CHANNEL Selector buttons Dash buttonPIP button POP Mode PICTURE-IN-PICTUREPress the Cursor PAD or to enable the sub-picture sound PICTURE-IN-PICTURE PIPNtsc PIP Mode PICTURE-IN-PICTURESplit Mode PICTURE-IN-PICTURE Surf Mode PICTURE-IN-PICTUREMain Freeze Split FreezeStrobe Freeze Exclusive TV buttons HOW to USE the Remote To Control Cable BOX FunctionsOperating the precoded function for your cable box Precoded Cable BOX buttonsPRE-CODED SET-TOP-BOX/SATELLITE Receiver buttons These buttons transmit the chosen precoded DVD codes HOW to USE the Remote To Control DVD FunctionsOperating the precoded function for your DVD player Precoded DVD ButtonsHOW to USE the Remote To Control VCR/PVR Functions Precoded VCR/PVR ButtonsThese buttons transmit the chosen precoded VCR/PVR codes HOW to USE the Remote To Control Additional Audio Equipment Operating the precoded function for your Audio componentPrecoded Audio Buttons Input Access Remote VCR Brand Audio Brand ON-SCREEN Display OSD On-Screen DisplayFor Video AudioChannel Manager Locks Timers Setup Power Swivel Picture Mode VideoDisplay Contrast Noise Reduction Reset Video SettingsWhite Balance ON-SCREENColor Management Color DecodingAudio DRC Language Digital OutputVertical Position AspectAspect Auto AspectPress Cursor PAD To highlight Ant a or Ant B Channel ManagerSet The Antenna Auto Channel ScanChannel List Signal MeterLocks Movie Ratings TV Ratings Canadian Ratings English Table Canadian Ratings EngProgramming restricted to adults Contains Canadian Ratings FrnCanadian Ratings French Table Programming is not suitable for childrenSet The Clock TimersSet Day/Night Timer Set Sleep TimerPlease Set Clock First Set Event TimerSet Timer Recording Menu Preference SetupImage Power Menu BackgroundScreen Saver Screen Display Set The InputsPress Cursor PAD or Set Black Side Panel Channel Set Closed CaptionSet AV Control This feature will select the source of the Monitor OutputSet Monitor Out CableCARD InfoUpgrades Set Stand-By ModePower Swivel RGB on Screen Display Using the RGB InputOperation No SYNC. Signal Invalid Scan Freq Aspect Setup Power Swivel Move SEL Sel Video Aspect Setup Power Swivel Brightness Color TemperatureInput ContrastReset EnhancerAspect Using the RGB Auto AdjustPosition Clock Phase Phase to factory preset, for current RGB formatHorizontal Clock RGB Input UsingDo not Care of Your Hitachi Plasma Display Your Remote ControlIgnition Noise Reception ProblemsControl Useful Info SymptomsPicture Image Spectrum Useful InfoTrademark Acknowledgment Plug and PlayAgency Regulatory Information Outputs InputsHitachi Way Chula Vista, CA Home Electronics DivisionDigital Media Division 22-25 AccessoriesIndex TruBassOr the Software END User License Agreement for Hitachi DTV Software102 103 QR64291