Hitachi 55HDX61A important safety instructions Rear Panel Jacks, Monitor OUT

Page 11

REAR PANEL JACKS

Audio Video Control Center (AVC)

￿

Monitor Bottom View

 

FIRST TIME USE

Antenna Input

The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A input can be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture (ANT B cannot be displayed as a sub-picture).

Audio/Video Inputs 1, 2, 3 and 4

By using the INPUTS button, the CURSOR PAD ( and ), and the SELECT button or CURSOR PAD of the remote control, you can select each video source. Use the audio and video inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players etc. (if you have mono sound, insert the audio cable into the left audio jack).

MONITOR OUT

These jacks provide fixed audio and video signals (ANT A/B, INPUT 1~5) which are used for recording. Use the S-VIDEO Output for high quality video output. Component signal to Input 1 and 2, RGB and HDMI inputs will not have monitor output.

Optical Out (Digital Audio)

This jack provides Digital Audio Output for your audio device that is Dolby® Digital and PCM compatible, such as an audio amplifier.

S-VIDEO Inputs 3 and 4

Inputs 3 and 4 provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability.

NOTES: 1. You may use VIDEO or S-VIDEO inputs to connect to INPUT 3 and 4, but only one of these inputs may be used at a time.

2. S-VIDEO output may be used for recording, only when the input is of S-VIDEO type.

Component: Y-PBPRInputs

Inputs 1 and 2 provide Y-PBPRjacks for connecting equipment with this capability, such as a DVD player or Set Top Box. You may use composite video signal for INPUTS 1 and 2.

NOTES: 1. DO NOT connect composite VIDEO and S-VIDEO to Input 3, 4 or 5 at the same time. S-Video has a higher priority over video input.

2.Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the AVC Box’s PB input and the components R-Y output to the AVC Box’s PR input.

3.Your component outputs may be labeled Y-CBCR. In this case, connect the component CB output to the AVC Box’s PB input and the component CR output to the AVC Box’s PR input.

4.It may be necessary to adjust TINT to obtain optimum picture quality when using the Y-PBPRinputs (See page 56).

5.To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the Y-PBPRjacks, RGB and HDMI inputs.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Operating Guide for 55HDX61A Do not Open Important Safety InstructionsPublic Viewing of Copyrighted Material Read before operating equipmentPrevention of Screen Burn First AccessoriesUSE Time Antenna HOW to Setup Your NEW Hitachi Plasma TelevisionFirst Time USE Securing to a wallVertical Viewing HOW to SET UP Your NEW Hitachi Plasma TelevisionViewing BestHookup Cables First Time Antenna Connections to Rear Panel JacksUSE Photo Input Front Panel ControlsPhones Jack Monitor OUT Rear Panel JacksRGB Audio Input Upgrade CardTo Power Swivel Connector RGB Analog InputRear Panel of AVC CableCARD SlotConnecting External Video Sources Connecting Plasma Display Monitor to AVC BOXBefore Operating External Video Source Connecting a Monaural Audio Source to INPUT1~INPUT5Connecting a Stereo VCR or Stereo Laserdisc Player Connecting S-VIDEO VCR or Laserdisc Player DVI to Hdmi Input Hdmi inputSee page 27 for tips on Rear Panel Connections Digital VCR D-VHS Connecting External Audio Amplifier Connecting External AUDIO/VIDEO DevicesConnecting AV Network Setup Procedure Using AV Network Device Codes AV Network Setup WizardSpeakers to on or OFF, then press Select to set Remote controlUse the Cursor Pads To choose AV Receiver To select Internal SpeakersAUDIO/VIDEO Codes for AV Network not for remote control Time USE Rear Panel ConnectionsTips on Rear Panel Connections Remote Control Remote ControlHOW to USE the Remote To Control Your Plasma TV 480P Input RGB Analog Input Aspect Display ModeAspect button RatioGuide button DAY/NIGHT buttonPICTURE-IN-PICTURE button Menu buttonAV NET button ControlRemote AV NET Learning Wizard Select OK Softkeys. If the device responds, then it is properly set upIeee Inputs buttonPhoto Input Ant B Ant a Select this menu item to view the chosen picture number JumpRotate SlideshowWhen an IEEE1394 device is connected Video When an S-VIDEOInfo button Last Channel LC button Volume VOL WHEEL, Mute buttonChannel CH WHEEL/CHANNEL Selector buttons Dash buttonPIP button POP Mode PICTURE-IN-PICTUREPress the Cursor PAD or to enable the sub-picture sound PICTURE-IN-PICTURE PIPNtsc PIP Mode PICTURE-IN-PICTURESplit Mode PICTURE-IN-PICTURE Surf Mode PICTURE-IN-PICTUREStrobe Freeze Main FreezeSplit Freeze Exclusive TV buttons HOW to USE the Remote To Control Cable BOX FunctionsOperating the precoded function for your cable box Precoded Cable BOX buttonsPRE-CODED SET-TOP-BOX/SATELLITE Receiver buttons These buttons transmit the chosen precoded DVD codes HOW to USE the Remote To Control DVD FunctionsOperating the precoded function for your DVD player Precoded DVD ButtonsThese buttons transmit the chosen precoded VCR/PVR codes HOW to USE the Remote To Control VCR/PVR FunctionsPrecoded VCR/PVR Buttons Precoded Audio Buttons HOW to USE the Remote To Control Additional Audio EquipmentOperating the precoded function for your Audio component Input Access Remote VCR Brand Audio Brand ON-SCREEN Display OSD On-Screen DisplayFor Video AudioChannel Manager Locks Timers Setup Power Swivel Display Picture ModeVideo Contrast Noise Reduction Reset Video SettingsWhite Balance ON-SCREENColor Management Color DecodingAudio DRC Language Digital OutputVertical Position AspectAspect Auto AspectPress Cursor PAD To highlight Ant a or Ant B Channel ManagerSet The Antenna Auto Channel ScanChannel List Signal MeterLocks Movie Ratings TV Ratings Canadian Ratings English Table Canadian Ratings EngProgramming restricted to adults Contains Canadian Ratings FrnCanadian Ratings French Table Programming is not suitable for childrenSet The Clock TimersSet Day/Night Timer Set Sleep TimerPlease Set Clock First Set Event TimerSet Timer Recording Menu Preference SetupScreen Saver Image PowerMenu Background Press Cursor PAD or Screen DisplaySet The Inputs Set Black Side Panel Channel Set Closed CaptionSet AV Control This feature will select the source of the Monitor OutputSet Monitor Out CableCARD InfoPower Swivel UpgradesSet Stand-By Mode RGB on Screen Display Using the RGB InputOperation No SYNC. Signal Invalid Scan Freq Aspect Setup Power Swivel Move SEL Sel Video Aspect Setup Power Swivel Brightness Color TemperatureInput ContrastAspect ResetEnhancer Position Using the RGBAuto Adjust Horizontal Clock Clock PhasePhase to factory preset, for current RGB format RGB Input UsingDo not Care of Your Hitachi Plasma Display Your Remote ControlIgnition Noise Reception ProblemsControl Useful Info SymptomsPicture Image Spectrum Useful InfoTrademark Acknowledgment Plug and PlayAgency Regulatory Information Outputs InputsHitachi Way Chula Vista, CA Home Electronics DivisionDigital Media Division 22-25 AccessoriesIndex TruBassOr the Software END User License Agreement for Hitachi DTV Software102 103 QR64291
Top Page Image Contents