CONNECTION (continued)
Connecting Procedure
This unit is ready for various kinds of connections. Make a connection in the following steps. Be sure to turn off the Main Power fi rst when connecting external equipments.
1.Connect Power Cord to the rear panel.
2.Connect Aerial Lead.
3.Connect your external equipments to the unit if any.
4.Connect the Power Plug to the Wall Socket.
ENGLISH
1. Connecting Power Cord to the Rear Panel
Connect Power Cord to the unit.
*Make sure not to connect the Power Plug to the Wall Socket until all connections are completed.
2. Connecting Aerial Lead. |
|
There are two ways to connect Aerial Lead. | STB |
When you do not have any other external equipment: |
|
Connect the Aerial Lead directly into the Socket at rear panel.
When you have one or more external devices to connect: | IN | IN |
1. Use RF cable to connect between each equipment and aerial. | OUT | OUT |
2.Connect the Aerial Lead to the Aerial Input socket of an external device such as a VCR.
3.Connect the RF cable from the equipment ‘Out’ to the other equipment ‘In.’
4.Then, connect from the equipment ‘Out’ to “ANT” on the LCD screen Socket.
VCR
IN
OUT
NOTE
If analogue and digital broadcast signals are provided from separate aerials, please use a mixer and RF cable to connect aerial socket in order to receive both signals.
Precautions when connecting the aerial
Please use a coaxial cable which is free from interference to connect the aerial.
Avoid using indoor aerial as this may be affected by interference. Please use outdoor aerial.
If noise appears in the picture, please use a
15
Downloaded From