Hitachi 55VG825 Equipment Care and Troubleshooting, Do not, Switch ON/OFF

Page 92

Equipment Care and Troubleshooting

DO

Dust the screen and cabinet with a soft cloth.

Clean the screen with a soft cloth moistened in warm water and dry with a soft cloth. A mild soap may be used if the screen is extremely dirty.

Place your Television away from extreme heat, humidity, and extremely dusty places.

Remove the plug from the wall outlet if your Television will not be used for a long period of time, for instances, when you go on vacation.

DO NOT

Do not clean your screen or cabinet with strong cleaners, polishes or a chemically treated cloth.

Do not place rubber or vinyl products or cellophane tape on your Television.

Do not touch the screen too often.

Do not subject the remote control to shocks such as dropping it on the floor, etc. Physical damage to the precision parts may result.

Avoid placing the remote control in a high humidity place or getting it wet. Do not leave it on or near a heater. Excessive heat or moisture may cause the unit to cease operation.

When the batteries run down, remote control operation will become erratic or possibly stop altogether. Replace the old batteries with two new “AA” size batteries as soon as possible to preserve the remote control precodes that were set for the devices. Pressing a remote control button with a “DEAD” battery might erase all precodes in memory. Do not use an old battery with a new battery.

Exposure of the viewing screen to prolonged direct sunlight or heat may cause the screen to permanently warp, resulting in a distorted picture..

Useful Information

TROUBLESHOOTING

HITACHI LCD Rear Projection Television incorporates advanced power surge protection technology designed to protect against component or circuit damage due to external or internal voltage power surges.

IF YOUR TELEVISION SHOULD APPEAR TO HAVE A LOSS OF POWER, PLEASE FOLLOW THIS PROCEDURE:

1. Press the POWER

SWITCH (ON/OFF

SWITCH) once.

2. If there is still no power, wait 30 seconds and press the POWER

SWITCH again.

3. If there is still no power, unplug the power cord from the wall. Wait 30 seconds and plug the power cord back in. Press the POWER SWITCH again.

This protective technology should provide for years of lasting entertainment from your HITACHI LCD Rear Projection Television.

92

Image 92
Contents LCD Rear Projection Television Important Safety Instructions Read Before Operating EquipmentPower source ModificationsPublic viewing of copyrighted material Lead NoticeFor U.S. models AccessoriesRemote Control Battery Installation and Replacement How to set up your new Hitachi Projection Television AntennaLocation ViewingHook-up Cables and Connectors Antenna Connections to Rear Jack PanelQuick Reference Remote Control Buttons and Functions Mode IndicatorFront Panel Controls Side Input Jacks InputPower Light Temp IndicatorLamp Indicator Photo InputSide Panel Jacks and Connections Rear Panel Connections CableCARD Slot TV AS Center InputsIR Blaster/G-LINK Tips on Rear Panel Connections VIDEO,Y-PBPRand HdmiConnecting External Audio Sources Speaker placementConnecting External Video Sources Before Operating External Video SourceConnecting a Composite Video Connecting a Component Source with Connecting a Component VCR Sensor Cable Box Remote Control Automatic Mode Default modeHow to Use the Remote to Control Your TV Mode IndicatorSource Access or buttons Source Access ENT buttonZOOM1/ZOOM2 StandardExpanded ANALOG/DIGITAL Channels AIRCursor PAD How to Use the Remote to Control Your RotateVolume VOL WHEEL, Mute button Last Channel Last CH buttonChannel CH WHEEL/CHANNEL Selector buttons Dash buttonPIP button POP Mode PICTURE-IN-PICTUREPicture-In-Picture PIP Surf Mode PICTURE-IN-PICTURE PIP Mode PICTURE-IN-PICTURESplit Mode PICTURE-IN-PICTURE Strobe Freeze Split FreezeMain Freeze Remote Control for Cable Box Functions Operating the precoded function for your cable boxPrecoded Cable BOX buttons Exclusive TV buttonsRemote Control for Set-Top Box/Satelite Receiver Functions PRE-CODED SET-TOP-BOX/SATELLITE Receiver buttonsMY Satellite Receiver SET-TOP-BOX Code isRemote Control for DVD Functions Operating the precoded function for your DVD playerPrecoded DVD Buttons MY DVD Player Code isMY VCR/PVR Code is Remote Control for VCR/PVR FunctionsPrecoded VCR/PVR Buttons Remote Control for Additional Audio Equipment Operating the precoded function for your Audio componentPrecoded Audio Buttons MY Audio Component Code isHow to Use the ENT Button Input AccessRemote Control Codes VCR Brand CodeSET TOP BOX BRAND..CODE On-Screen Display TV Guide On Screen Video OFF ModeBlack Side Panel Reset Video SettingsVertical Position BBE AudioSRS Second Audio Program SA Stereo STMono DRC LanguageDigital Output TV Guide On Screen To Setup the TV Guide On Screen SystemSetup Procedure TV Guide On Screen TV Guide On Screen TV Guide On Screen TV Guide On Screen Using the TV Guide On Screen System Navigating the TV Guide on Screen System ScheduleTV Guide On Screen Icons Name DescriptionGO to Service BAR CancelListings Tune to Channel / Watch NOWSearch Example Category Search MoviesExample Keyword Search To Edit or Delete a keywordEdit Search Delete SearchSchedule Watch NOW/TUNE to ChannelDelete Recording Edit RecordingRecording Notification Banner How to RemindRecording Conflict How to set a reminder TileSetup Reminder Notification BannerRemind Conflict Remind conflict message will appear if Select these optionsChange System Settings Change Channel DisplayChange Default Options General Default OptionsRecord Defaults Remind DefaultsIR Defaults Channel Manager Signal MeterSignal Meter Start or Reset option Favorites settingsAuto Channel Scan Channel ListChange Access Code LocksMotion Picture Ratings Table Locks Rear Panel JacksMovie Ratings TV Ratings TV Parental Guide Ratings TableCanadian Ratings Eng Canadian Ratings English TableCanadian Ratings French Chart Timers Set The ClockPress Cursor PAD Cursor PADSet Sleep Timer Set Day/Night TimerON. Using Cursor PAD OFF. Using Cursor PADSolid SetupSET the Menu Background Shaded or Lamp Power Control Set The InputsInput 4 Auto Link Set AV NetAV NET Setup Wizard Example A/V Receiver Setup AV NET Setup Wizard Example DVD Setup NET Setup Learning ModeUse the Cursor PAD Select the Soft Key to learn Ex. VOL Learning Mode Example CUSTOM/DVD 3 Setup To move on to the next Setup screen Setup Caption Mode Set Closed CaptionCaption Display Analog CaptionsSet Monitor Out MonitorTV Tuner Out FixedANT Upgrades Upgrade NOWInsert MMC Card Quick Start UpLamp Life Lamp ReplacementLamp Replacement 120V Useful Information Phillips Head Screw Driver Lamp Compartment Equipment Care and Troubleshooting TroubleshootingSwitch ON/OFF Do notTV Guide On ScreenTM System Frequently Asked Questions What do the frequencies for Record and Remind mean? How can I look for a specific show in the Guide?Reception Problems Features and Specifications FeaturesDimensions InputsHome Electronics Division Digital Media DivisionCanada 1-800-HITACHI Meadowpine Blvd Mississauga, Ontario L5N 6C3End User Licence Agreement for Hitachi DTV Software END User License Agreement for Hitachi DTV SoftwareAppendixes Image Input Type Format Aspect Video ID Auto AspectAppendix E Information and press the Select buttonIndex Locks102 103 QR64431