Magnavox 27TP83 C101 owner manual O91

!I Vour TV remote can be set to

-• work your VCR or Cable Converter by what is called the SEARCH method.

lf the "REMOTE CODE" number method shown in the previous

	section did not set your remote to
	work your VCR or Converter, then
	fi_llow the easy steps listed below.
	Please read through steps 1-4
	before beginning.
<_	Press the POWER button on
	unit ON.
	the VCR or Converter to turn the
<_	Stand at least six feet away
	from the front of the VCR or
	Converter.
	Point the remote toward the unit.
	HOLD DOWN the SURF and
	the desired System (VCR or
	CBL-Converter) buttons at the
	same time. KEEP HOLDING
	B U'I_ONS DOWN.
	Watch the Channel Indicator
	on the unit.
	Channel Numbers will SCAN UP
	when the unit has been identified.
	This may take up to two minutes.
	Release the SURF and System
	(VCR or CBL) buttons as soon
	as channel numbers start to scan
	up. The code has been identified
	and the remote is ready to operate
	with the VCR or Converter.
	O

Remember, a minute or two can seem very long, but

the code should be located within two minutes.

Don't let the VCR scan up more than five channels. If you do the

remote may pass up the right code and another two minute search

cycle will have to be repeated.

"If no channel change happens

¢¢ithintwo minutes, repeat steps 1-

not occur, the remote will not work

4with. Shouldthe desireda channelunit. change still

CABLE CONVERTER

o91

09 . f

Six Feet

(minimum)

1

=888