Work

lease make these simple checks before calling for

service. Theses tips can save you time and money since charges for TV installation and adjustment of customer controls are not covered under your warranty.

NO Power

No Picture

No Sound

Remote Does Not

iCAUTION: A video source (such as a video game, Compact Disc Interactive - CDI, or iTV information channel) which shows a constant non-moving pattern on the TV screen, can cause picture tube damage. When your TV is continuously used with such a source the pattern of the non-moving portion of the game (CDI, etc.) could leave an image permanently on the picture tube. When not in use, turn the video source OFF. Regularly alternate the use of such video sources with normal TV viewing.

Check the TV power cord. Unplug the TV, wait 10 seconds, then reinsert plug into outlet and push POWER button again.

Check to be sure outlet is not on a wall switch.

Check antenna connections. Are the properly secured to the TV's ANT/CABLE plug ? Check the CABLE/YES NO control for correct position.

Check INPUT control for correct position. VCR-AUX or S-VIDEO position without a signal source will result in a blank screen. Also the TV's S-VIDEO Input plug cannot be used as another video source to be shown in the PIP window.

Check the VOLUME buttons.

Check the MUTE button on the remote control.

Check the SPEAKER on-screen control. OFF position will eliminate sound at the set. If attempting auxiliary equipment hook-ups, check audio jack connections.

Check TV-VCR-CBL "System" buttons on the remote. Press the remote's "IV System button to send commands to the TV.

Check batteries. Replace with AA Heavy Duty (Zinc Chloride) or Alkaline batteries if necessary.

Clean the remote and the remote sensor window on the TV.

Check the 'IV power cord. Unplug the TV, wait 10 seconds, then reinsert plug into outlet and push POWER button again.

Check to be sure TV outlet is not on a wall switch.

TV Displays Wrong

Channel or NO

Channels Above 13

Add desired channel numbers (CHANNEL control) into TV memory.

i Repeat channel selection.

Check CABLE/ YES NO control for correct position.

This TV is equipped with protective circuitry that shuts the "IV off in case of moderate power surges. Should this occur tum the TV back on by pressing the POWER button once or twice, or unplug (wait l0 seconds) and then replug the power cord at the AC outlet. This feature is NOT designed to prevent damage due to high power surges such as those caused by lightning, which is not covered by your warranty.

Cleaning and Care

•To avoid possible shock hazard be sure the TV is unplugged from the electrical outlet before cleaning.

•When cleaning the TV screen take care not to scratch or damage the screen surface (avoid wearing jewelry or using anything abrasive). Wipe the front screen with a clean cloth dampened with water. Use even, easy, vertical strokes when cleaning.

•Gently wipe the cabinet surfaces with a clean cloth or sponge dampened in a solution of cool clear water. Use a clean dry cloth to dry the wiped surfaces.

•Occasionally vacuum the ventilation holes or slots in the cabinet back.

•Never use thinners, insecticide sprays, or other chemicals on or near the cabinet, as they might cause permanent marring of the cabinet finish.