What’s on the Remote?

Xtender Channel Activity Lights	1	18.	Power
Xtender Channel Buttons	2	19.	Local TV
Menu	3	20.	Live TV
Info and “A”	4	21.	Guide and “B”
Exit and “C”	5	22.	Last and “D”
Mute	6	23.	Shift
Up	7	24.	Right
Left	8	25.	Select/OK
Down	9	26.	Channel +/-
Vol +/-	10	27.	Fast Forward
Play	11	28.	Pause
Rewind	12	29.	Skip
Stop/Slow	13	30.	Record
Replay and “PIP”	14	31.	Enter
+100	15	32.	Cable/Satellite
Number Keypad	16	33.	DVD/VCR/Laser Disk
Del/Clear	17	34.	AUX

Those Needing a Little Explanation

1.Xtender Channel Activity Lights – blink when you send a command to one of the devices connected to Xtender. For instance if you press the Red BOCS channel button, then push play the red light flashes letting you know that the play command went to the Red channel.

2.Xtender Channel Buttons – The three new channels in your home – press RED to watch and control whatever is plugged into the Red input on Xtender (same for GREEN & BLUE)

3.Menu – the DVD, DVR, or TiVo menu command, depending on what you are controlling

4.Info/ “A” –push shift/info for “A”, a button common for cable boxes

13.Stop/Slow – For most DVD players this is “Stop”, but many DVRs (Like TiVo DVRs) do not commonly have a Stop button so in those cases, this becomes the “Slow Play” button

14.Replay – typically makes a DVR go back about 15 seconds and play a clip again. For DVD it skips backward and if you push Shift first it is the “PIP” or Picture-in-Picture button

15.+100 – Shift-1 gives the +100 command, sometimes used to get to channels that are >100

18.Power – In general, this button turns your TV on and off. If this is pressed within 10 seconds of pressing a BOCS channel button, it powers on/off the device plugged into that Xtender channel (if the DVD player on the Red channel is off – just press Red and Power within 10 seconds). Press Shift-Power to power-down the Xtender system (so any Cable or Antenna channels that you cannot watch when Xtender is on are now visible). A double flash indicates programming success, a fast flash indicates programming error, and an alternating Power and Xtender Channel lights (Red/Green/Blue) indicates remote is out of range of Xtender.

19.Local TV – After watching a BOCS channel, pressing this button returns you to watching normal Cable/Antenna through your local TV. So you know you are back to local control, the remote automatically tunes to the “Favorite TV channel” (see programming your remote).

34.AUX – Any set of codes can be programmed into this mode button but it is most commonly used for an audio receiver. Note that if you use a separate receiver to listen to your TV you can make the VOL+/- button always send volume commands to the AUX device instead of directly to the TV by following the “Punch Through” procedure in “Setting Up the Remote”

Installing the SuperCombiner