Epson Bocs installation manual Programming the Remotes

	is not as good as my	channels depending on what you want to
	Cable TV channels on	watch – but Xtender needs to know
	the TV connected to	which remote control you are using with
	the LOCAL-TV output	this “Local-TV” so it can switch those
	on Xtender	signals to the TV properly – simply hold
		down Menu and VOL+ then press
		select/OK – Now when you press an
		Xtender channel button, the Local-TV
		output puts out a good quality Xtender
		channel signal, and when you press
		Local-TV it switches back to putting out
		good quality Cable TV signals
	Sometimes, when	One of the other remotes in the home
	watching BOCS	has also been set as the “local master
	channels on the TV	remote” – and when someone pushes
	connected to the	the local-TV button, the Xtender stops
	Local-TV output on	putting out good quality Xtender
	Xtender, the quality	channels to the TV connected to Xtender.
	of the video suddenly	Simply go to all the other remotes in the
	goes bad	home and hold down Menu and VOL-
		then press Select/OK -
Remote	Sometimes pressing	Make sure the remote is paired with the
control	a button does not	Xtender – you can tell this by going to
	result in anything	Xtender with the remote in question,
	happening on an	pressing an Xtender channel button and
	Xtender channel	seeing if the corresponding color light on
		Xtender flashes – if not pair the remote.
		Look at the Xtender Channel light on the
		remote – when you press the Xtender
		channel button, if the light sometimes
		flashes and sometimes stays on for a few
		seconds, the remote is having trouble
		communicating with Xtender. Try the
		following:
		Make sure the antenna on the Xtender is
		pointed straight up.
		Try moving closer to Xtender and see if
		the problem goes away.
		Consider buying a repeater to Xtend the
		range of your remotes
	I’ve tried all the codes	Try a TV code scan – see the procedure
	for my TV and none	in the “programming the remote
	of them work	section.”
		Try a FULL code scan – use the same
		procedure but omit pressing the “Local-
		TV button” after entering scan mode –
		this will scan through all 2000 codes in
		the remote – it might take a while.
		Consider purchasing a learning remote
		so you can suck the codes from the
		remote that originally came with your TV
		into an Xtender remote.

Programming the Remotes 31