Epson Bocs installation manual Installation Overview, Easy as

Page 9

Installation Overview

Easy as 1-2-3

Step 1 – Install SuperCombiner

The SuperCombiner is a device that is installed just before your main home “root splitter” to distribute your new BOCS channels all over your home. In this step you will:

Decide where to put your Xtender.

Plug a special Cable-Finder into the nearest CATV outlet. Find and open your cable splitter box.

Find the coaxial wire that goes to the room where you put Xtender. Install the SuperCombiner.

Step 2 – Install the Xtender Unit

Xtender is connected to the three devices you want to control (just like hooking up a new DVD player).

Xtender is connected (using stick-on IR emitter cables) to each of those same three devices so Xtender can control them.

Xtender is connected to power and the Coax wall jack. Step 3 – Program the Remote Controls

By punching in a few codes, the remote controls are programmed so they know how to control both local TVs as well as the devices plugged into Xtender.

Setup should take no more than 20 minutes for a typical home

A Quick Start Guide is provided in the Xtender package with large pictures of the entire installation.

Installing the SuperCombiner

9

Image 9

Contents Installation Manual Contents Welcome to the World of Whole-Home Entertainment Choices ChapterNow You Can… Without…What You Need Xtender Installation KitTools XtenderRemote Control Lights What’s on the Front Panel? What’s on the Back Panel? Those Needing a Little Explanation What’s on the Remote?Easy as Installation OverviewSelect Location for the Xtender Power the Coax WireMinimum Location Requirements Likely Locations Choose OneLocate your cable box Locate the Splitter Find the Powered CableConnecting the SuperCombiner Installing the Xtender Connect XtenderConnect the Audio/Video devices to the Xtender Connect the Device to the Xtender Red Channel Set UpGreen Channel Set Up Connect the IR BlasterConnect the A/V Device to the Xtender Connecting Xtender’s Power Supply Blue Channel Set UpChecking Power Supply Optional Connect to the local TVRemote Control Setup for Local TV Three Steps to Programming the Remotes Programming the RemotesPair Remotes Pick a room, program a remote to work the TV in that roomProgram the Xtender to Control the A/V Devices Alternate Remote programming procedure for TV Auto-ScanEnter the device code press Select/OK to confirm Program the rest of your remotes for each room Set the master remoteTo set or remove the remote as a Local Master More Programming Options Volume Punch-ThroughControl other devices in the same room as the remote Punch-ThroughChannel Punch-Through Learn IR CodesHave the Bocs Remote Learn IR Codes from Another Remote Unlearn IR Codes Have the Xtender Learn IR Codes from Another RemoteChannel Tuning Delay Adjust the Video quality of Xtender channels Using the Remotes Programming the Remotes Troubleshooting Programming the Remotes Programming the Remotes Programming the Remotes Programming the Remotes Television Device Codes Appendix aTelevision RCA Plasma TVSVA TMKTV/DVD Combination TV/VCR CombinationTV/VCR/DVD Combination Appendix B Cable & Satellite Box Device CodesCable Box Satellite BoxAppendix C Video Device CodesDVD Player AMWABS Laser Disk PlayerCCE HI-QDigital Video Recorder DVR Auxiliary Device Codes PCS Home AutomationProcedure Remote Control Special Function Quick Reference