Emerson SLC195EM8 2 owner manual 5Troubleshooting Guide

Page 27

TROUBLESHOOTING

5Troubleshooting Guide

If the unit does not perform properly when operated as instructed in this owner's manual, check the following chart once before calling for service.

Symptom	Remedy
No power	• Be sure the power cord is plugged in.
	• If a power failure occurs, unplug the power cord for 30 minutes to allow the unit to
	reset itself.
No picture or sound	• Check if the power is on.
	• Check the outlet connection.
	• Check the antenna or cable connection to the main unit.
	• When the outside antenna is used, check the wire condition and connection.
	• View other TV channels. The problem might be limited to the broadcasting station.
	• Turn off the power and wait for about 1 minute, then turn it on again.
No color	• Check the antenna or cable connection to the main unit.
	• When the outside antenna is used, check the wire condition and connection.
	• View other TV channels. The problem might be limited to the broadcasting station.
	• Adjust the “COLOR” in the main menu.
Sound OK, picture poor	• Check the antenna or cable connection to the main unit.
	• When the outside antenna is used, check the wire condition and connection.
	• Electrical interference from nearby appliances may affect picture quality.
	• Adjust “CONTRAST” and “BRIGHTNESS” in the main menu.
	• View other TV channels. The problem might be limited to the broadcasting station.
Picture distorted	• When the outside antenna is used, check the wire condition and connection.
	• View other TV channels. The problem might be limited to the broadcasting station.
Weak picture	• Check the antenna or cable connection to the main unit.
	• When the outside antenna is used, check the wire condition and connection.
	• Adjust “CONTRAST” and “BRIGHTNESS” in the main menu.
	• View other TV channels. The problem might be limited to the broadcasting station.
Lines or streaks in picture	• When the outside antenna is used, check the wire condition and connection.
	• Electrical interference from nearby appliances may affect picture quality.
	• View other TV channels. The problem might be limited to the broadcasting station.
Picture blurred	• When the outside antenna is used, check the wire condition and connection.
	• View other TV channels. The problem might be limited to the broadcasting station.
Ghosts in picture	• Check the antenna or cable connection to the main unit.
	• When the outside antenna is used, check the wire condition and connection.
	• Electrical interference from nearby appliances may affect picture quality.
	• View other TV channels. The problem might be limited to the broadcasting station.
Bars on TV screen	• When the outside antenna is used, check the wire condition and connection.
	• Electrical interference from nearby appliances may affect picture quality.
Picture rolls vertically	• When the outside antenna is used, check the wire condition and connection.
	• Electrical interference from nearby appliances may affect picture quality.
	• View other TV channels. The problem might be limited to the broadcasting station.
Different color marks on TV	• Move the unit away from nearby electric appliances. Turn off the power and wait
screen	30 minutes before turning it back on.
	• View other TV channels. The problem might be limited to the broadcasting station.
Poor reception on some	• Check the antenna or cable connection to the main unit.
channels	• When the outside antenna is used, check the wire condition and connection.
	• Electrical interference from nearby appliances may affect picture quality.
	• View other TV channels. The problem might be limited to the broadcasting station.
Picture OK, sound poor	• View other TV channels. The problem might be limited to the broadcasting station.

No reception of digital signals	• Make sure auto channel scan has been completed. (Refer to “Auto Channel Scan”
	on page 12.)
	Auto channel scan must be completed when you set up the unit for the first time
	or move it to a location where previously unavailable channels are broadcast.
	• The selected channel may not be broadcasting.
	• When auto channel scan is interrupted and not completed, some channels will not
	be received. Make sure to complete. (Refer to “Auto Channel Scan” on page 12.)

INTRODUCTION PREPARATION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION

27

EN

Image 27

Contents SLC195EM8 To Receive DIGITAL/ANALOG SIGNAL, YOU Must Connect AntennaIntroduction PrecautionsRADIO-TV Interference Location and HandlingTo Avoid the Hazards of Electrical Shock and Fire 5Trademark Information 5Supplied Accessories5Symbols Used in this Manual 5Attaching the StandContents Features5Installing the Batteries 5Buttons on the Remote Control5Rear Panel 5Control PanelConnection to Cable Box or Satellite Box Preparation5Basic Connection Antenna Connection5External Device Connection Component Video ConnectionVideo Connection PC Connection Initial Setting 5Initial Setup5Main Menu 5Auto Channel Scan 5Language SelectionEnglish Español Français VIDEO2 Analog ModeWatching TV 5Channel SelectionSAP 5Switching Audio Mode5Sleep Timer MainProgram Guide 5Screen InformationOFF Broadcasting InformationFullexpand Side CUT 5TV Screen Display ModeSidebar Wide Fullmovie WideFor PC input signal 5Channel Add/Delete Optional SettingTint Sharpness 5Picture Adjustment5Closed Caption Brightness ContrastOFF 5DTV Closed Caption5DTVCC Style 5Back Light Setting 5Color TemperatureBright Normal Warm Dark Cool TV Rating ChipTo Set the Sub Ratings Mpaa RatingEnter password again in Confirm Password space Change Password5PC Settings CLOCK, PhaseAuto Adjustment 5Troubleshooting Guide TroubleshootingMaintenance With an AM radioWith a digital camera Including built-in cell phone cameras Information Limited Warranty SLC195EM8 Introducción PrecaucionesNúmero de serie Nota para el instalador del sistema Catv 5Accesorios Suministrados 5Conectar el Soporte5Base Inclinable Contenido CaracterísticasSleep 5Botnes en el Mando a Distancia5Instalación de las Pilas Mute5Panel Trasero 5Panel de ControlConexión a Caja de Cable o Caja de Satélite Preparación5Conexión Básica Conexión de Antena5Conexión de Dispositivo Externo Conexión de Vídeo en ComponentesConexión de S-video Conexión de Vídeo Conexion de PCMonitor 5Configuración Inicial Ajuste Inicial5Menú Principal Reglage DU PC 5Selección de IdiomaLUZ DE Fondo TENPE. DE Color¿Qué es el canal menor? 5Selección de CanalUtilizando los botones numéricos Acerca de la emisión de televisión digital5Temporizador de Apagado Para Cancelar el Temporizador de ApagadoPara VER LA Televisión 5Para Cambiar el Modo de AudioInformación de Emisión 5Información de PantallaInformación DE Emisión OFFTotalamplía Cortes Laterals 5Modo de Visualización de Pantalla del TelevisorSidebar Totalcine AnchaTipo de pantalla Resolución Para señal de entrada PCPresione Setup para salir Ajuste Opcional5Agregar/Borrar Canales 5Ajuste de Imagen 5SubtítulosModo de Subtítulos Pueden utilizarse abreviaciones, símbolos y otras 5Subtítulos en DTVColor ADELANTE, Color Fondo 5Estilo DtvccTamaño Titulo Borde CaracterPuede ajustar el modo de brillo deseado Presione Setup para salir5Ajuste de Luz de Fondo 5Temperatura de ColorLuego presione Enter Cuando no haya configurado su contraseña, introduzcaEj. TV-PG Para Ajustar las SubcategoríasVuelva a introducir la contraseña en el espacio Cambiar ContraseñaHaga el ajuste Reglage DU FLOU, Mise EN Phase5Ajustes de PC Ej. modo PC5Guía de Solución de Problemas Solución DE ProblemasCon una cámara digital MantenimientoInfrarrojos Con una radio AMInformación Garantía Limitada