Vidikron Vision 100t, Vision 90t manual RS-232 Control System Connection

Installation

Use a standard, 9-pin RS-232 cable to connect a PC or home theater control/automation	RS-232 Controller
system (if present) to the RS-232 CONTROL port on the Vision 90t/100t; see Figure 3-10.	Connection
For more information about using this connection, refer to Serial Communications on
page 49.

				TRIGGERS
				TRIGGERS
			1	2	3	IR
			1	2	3	IR
					1 VIDEO-S
VIDEO COMPONENT					S-VIDEO 1	CONTROL
Pb	Pr	Y	VIDEO			232-RS
					2 VIDEO-S
					S-VIDEO 2
Pb	Pr	Y	VIDEO			RS-232
COMPONENT VIDEO						CONTROL

5 4 3 2 1

9 8 7 6

2 Transmit Data

3 Receive Data

5 Ground

(none of the other pins are used)

to Automation/ Control System or PC

Figure 3-10. RS-232 Control System Connection

If your Vision 90t/100t is equipped with a CineWide with AutoScope system, use the cable supplied with the AutoScope Lens Motor to connect the motor to a 12-Volt trigger output as shown in Figure 3-11.

TRIGGERS

1 2 3 IR

Connecting 12-Volt Trigger

Outputs to External Theater

Equipment

Pb	Pr	Y		S-Video 1
	Component Video		Video	S-Video 2	RS-232 Out	RS-232 Control

3.5-mm mini plug

to AutoScope Lens Motor

Figure 3-11. Connecting a 12-Volt Trigger Output to the AutoScope Lens Motor

Vidikron Vision Model 90t and Model 100t Owner’s Operating Manual 25