Vidikron Vision 90t, Vision 100t Remote, Picture Brightness Contrast Color Tint Sharpness

Operation

Table 4-1. Aspect Ratio Settings (continued)

	Remote
Aspect Ratio	Control		Description
	Key
Cinema	CINEMA			Select Cinema to view 2.35 source
				material in its native aspect ratio.
				With a 16:9 screen and a
				non-CineWide projector (no
		2.35:1 Image on		anamorphic lens), the upper and
		16:9 Screen		lower portions of the screen are
		(without CineWide)
				masked, but the geometry of the
				active image area is unchanged.
				With a 2.35:1 screen and a
		2.35:1 Screen		CineWide-equipped projector,
				the projector vertically
		2.35:1 Image on
		(with CineWide)		stretches the 2.35 image so that
				the active image area fills the 16:9
				chip surface, eliminating the
				black bars. The secondary
				anamorphic lens then stretches
				the image back to 2.35:1.
IntelliWide 2.35	SVC			A 16:9 image is scaled
				NON-linearly (more on the sides
		16:9 IImage on		than in the center) to fit a 2.35:1
		22..35:1 Screen		screen.
				IntelliWide 2.35 is available only
				on CineWide-equipped Vision
				90t/100t projectors.
		16:9 Image on
		2.35:1 Screen with
		VirtualWide 2.35

Picture ➤

Picture

Brightness

Contrast

Color

Tint

Sharpness

Use the controls in the Picture Menu to calibrate your Vision 90t/100t for optimum picture quality.

All signal types require separate processing. Therefore, you need to calibrate each input separately.

The Vision 90t/100t has been designed to incorporate setup and calibration standards established by the Imaging Science Foundation (ISF). The ISF has developed carefully crafted, industry-recognized standards for optimal video performance and has implemented a training program for technicians and installers to use these standards to obtain optimal picture quality from Vidikron video display devices. Accordingly, Vidikron recommends that setup and calibration be performed by an ISF certified installation technician.

When you change a picture quality setting, save the change to a preset

Note afterwards. Otherwise, the change will be lost when a different input is selected. (Picture quality settings are saved for each input separately.) For information about saving settings, refer to ISF Presets on page 37.

32 Vidikron Vision Model 90t and Model 100t Owner’s Operating Manual