Vidikron Vision 90t Lens Replacement, Only trained, authorized Vidikron dealers should attempt to

Maintenance and Troubleshooting

5.2

Lens Replacement

If you need to remove the lens – either to replace it or to prepare the projector for shipment – proceed as follows:

Only trained, authorized Vidikron dealers should attempt to

Note remove or replace a lens. Please read this procedure carefully before doing so.

Lens replacement is normally performed at the Vidikron factory. Field replacement of lenses is generally only required if the projector is re-installed in a new location or the lens has been damaged.

1.Power down the projector and wait five minutes to allow the lamp to cool.

2.Remove the secondary anamorphic lens, if present.

3.Loosen the two, captive Phillips screws at the top and bottom of the front lens decorative bezel. Then, remove the bezel.

4.Using the 3.0-mm hex driver provided with the projector, loosen the three Allen screws on the outer ring of the lens assembly.

5.Gently pull the lens assembly straight out to remove it.

46 Vidikron Vision Model 90t and Model 100t Owner’s Operating Manual