5Maintenance and Troubleshooting
The lamp should be replaced when it reaches the end of its life (typically 2000 hours), or sooner if a noticeable degradation in brightness occurs. Contact your Vidikron dealer to obtain a replacement lamp.
1.Turn off the projector and unplug the power cord.
Allow the projector to cool down for approximately 45 minutes prior to removing the
lamp assembly for replacement.
2. Remove the three screws from the lamp cover.
3.Remove the lamp cover.
4.Remove the two lamp assembly mounting screws.
5.Grasp the lamp assembly handle and pull gently, removing the lamp module from the projector
housing.
6. Install the new lamp module and replace the two screws.
7.Replace the lamp cover at the top first and secure it
with the three screws.
8. Turn on the power and select Lamp Reset Timer from the Service menu to reset the lamp timer (refer to Lamp Reset Timer on page 58).
5.1
Lamp Replacement
Vidikron Vision 50 Series Owner’s Operating Manual | 63 |