TANDBERG |
|
Telepresence T3 | bottom modules |
Tip! The procedure outlined in this chapter suggests that you mount all three bottom modules before you mount the monitors on top of these modules.
As an alternative, you may prefer to mount each bottom module / monitor set completely before proceeding to the next bottom module / monitor.
Caution! Regardless of the method preferred, the cables between the DNAM modules and the monitors must be connected to the DNAM modules before you mount the monitors.
The cables are:
Cable 117850 to the left DNAM Cable 117852 to the center DNAM Cable 117856 to the right DNAM
4 × nut (b) M8 
Note! Retain the DVI to HDMI cable between monitor and codec plus three power cables.
119078.01 TELEPRESENCE T3 SYSTEM ASSEMBLY 12.08
1.Unpack the left system and take out the left Bottom module. Dismount the top screw on the right side in addition to the cable hatch cover.
2.The following cables must be disconnected and removed:
•112083 Ethernet Cable
•112980 Power Cable (main in)
•115233 PC Connection Cable (Video/audio in)
•117083 Main Speaker Cable (top of amplifier)
•117087
•118315 External Microphone Cable
•117084 Audio RCA Cable (Codec to amplifier).
3.Fasten by fastening 4 × nuts (b).
PAGE 14/58