TANDBERG | Mounting the |
Telepresence T3 | collaboration screens |
Tip! See the cabling diagram on page 39 and onwards for details on the cabling.
Note! The power cable supplied with the system is terminated with a standard IEC connector. An approved cable with a
119078.01 TELEPRESENCE T3 SYSTEM ASSEMBLY 12.08
6.While holding the Cable well, thread the audio, VGA and ethernet cables into the opening of the well. Fasten the cables with the cable clamp so that appr. 80cm of the cables are left outside.
7.Sink the cable wells onto the premounted screws. Fasten the screws and close the lid. If the lid is not flush with the table top, loosen the screws and adjust the cable wells. Then fasten the screws again.