TANDBERG T3 manual Mounting the TCU

Page 55

TANDBERG
Telepresence T3	Mounting the TCU

119078.01 TELEPRESENCE T3 SYSTEM ASSEMBLY 12.08

13.Unscrew the screws holding the bracket in the right Column. Switch on the Presentation input switch before mounting. Make sure the DIP switch is set correctly: 1: On, 2: Off, 3: On, 4: On, 5: On, 6: Off, 7: Off, 8: Off

Fasten it in the same manner as the TCU was fastened.

14.Place the cover plates left and right on top of the floor structure.

PAGE 55/58

Image 55

Contents Telepresence T3 Important information regarding room dimensions Telepresence T3 System assembly guideCeiling lights Telepresence T3Ceiling lights Telepresence T3Light mounting details Ceiling lightLight mounting details Telepresence T3Table Floor structure Do as follows Table Floor structure10/58 11/58 12/58 Do not step on the plates Bottom modules Bottom modules 16/58 17/58 18/58 Table Column Assembly Floor cabling structure From Kit No Drawing reference Art.No Cable bundling Structure in FloorTelepresence T3 Mounting the Column tray Assemblies Mounting the MonitorAssemblies Mounting the Monitor25/58 RJ45 RJ45 Mounting the CameraMounting the Camera System connections Cable Connection detailsSystem cabling structure Cable bundling in the systems Cable bundling in the systems System cable connections left system System cable connections center system System cable connections right system Table Top Module Table Top Module 37/58 38/58 Table connections Table cabling structure Keep signal and power cables apartCable RJ45 - RJ45 Cable HDMI - HDMI Cable bundling in the tableCable bundling in the table 43/58 44/58 Table cable connections left system Table cable connections center system Table cable connections right system Null-modem requirement Audio cable connections Table Connection notesCollaboration screens MountingCollaboration screens Mounting51/58 52/58 53/58 Mounting the TCU Mounting the TCU 56/58 57/58 58/58