TANDBERG T3 manual 38/58

Page 38

TANDBERG

 

Telepresence T3

Table Top Module

4 × screw (c)

119078.01 TELEPRESENCE T3 SYSTEM ASSEMBLY 12.08

8.Fit the two Table tighteners and tighten to remove the gap between the table top plates.

9.Find the Cable channels and insert them in the hole of the center table top, slide them out to left and right, respectively. The cable channels must be fastened with a screw (c) each.

10.Mount all the cables in the table as shown on the following pages.

PAGE 38/58

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Telepresence T3 Important information regarding room dimensions System assembly guide Telepresence T3Telepresence T3 Ceiling lightsTelepresence T3 Ceiling lightsCeiling light Light mounting detailsTelepresence T3 Light mounting detailsTable Floor structure Table Floor structure Do as follows10/58 11/58 12/58 Do not step on the plates Bottom modules Bottom modules 16/58 17/58 18/58 Table Column Assembly Floor cabling structure Cable bundling Structure in Floor From Kit No Drawing reference Art.NoTelepresence T3 Mounting the Column tray Mounting the Monitor AssembliesMounting the Monitor Assemblies25/58 Mounting the Camera RJ45 RJ45Mounting the Camera Cable Connection details System connectionsSystem cabling structure Cable bundling in the systems Cable bundling in the systems System cable connections left system System cable connections center system System cable connections right system Table Top Module Table Top Module 37/58 38/58 Table connections Keep signal and power cables apart Table cabling structureCable bundling in the table Cable RJ45 - RJ45 Cable HDMI - HDMICable bundling in the table 43/58 44/58 Table cable connections left system Table cable connections center system Table cable connections right system Table Connection notes Null-modem requirement Audio cable connectionsMounting Collaboration screensMounting Collaboration screens51/58 52/58 53/58 Mounting the TCU Mounting the TCU 56/58 57/58 58/58
Top Page Image Contents