Runco PL-50XA External Speaker Outputs, AUDIO1, AUDIO2, AUDIO3, DVD/HD2, DVD/HD3, DVD/HD4 Hdmi

Controls and Functions

1.POWER INPUT (100 to 240 VAC)

Connect the PlasmaWall to power here, using the included power cord.

2.EXTERNAL SPEAKER OUTPUTS

Not used. Connect speakers to an external audio amplifier/receiver.

3.VIDEO1, 2 (RCA, S-Video)

Not used. Connect all video sources to the DHD Controller.

4.AUDIO1, AUDIO2, AUDIO3

Not used with this model. Connect the audio outputs from your sources to an external audio receiver.

5.DVD/HD1

DVD/HD2

Not used. Connect all video sources to the DHD Controller.

6.PC/RGB (15-pin D-Sub)

Connect the RGBHV (5xBNC) output from the DHD Controller here.

7.DVD/HD3, DVD/HD4 (HDMI)

HDCP-compliant digital video inputs. Connect the DVI output from the DHD Controller to the DVD/HD3 input. (DVD/HD4 is not used.)

8.EXTERNAL CONTROL (9-pin, male D-Sub)

A male, 9-pin D-sub connector. Connect the RS-232 OUT port on the DHD Controller to this input.

9.REMOTE IN (3.5-mm mini phone jack, tip/ring/sleeve)

Wired input from an external remote control or infrared (IR) receiver.

10.REMOTE OUT (3.5-mm mini phone jack, tip/ring/sleeve)

Wired output to the REMOTE IN jack of another device; allows you to control both the PlasmaWall and the other device using the same wired remote control.

Runco PlasmaWall Owner’s Operating Manual 7