Runco PL-50XA manual Ventilation, Other Considerations, Prolong operating life

Installation

If you are mounting the PlasmaWall in an enclosure, leave at least 2 inches (50 mm) of	Ventilation
space on all sides between it and surrounding objects, as shown in Figure 3-2.This allows
heat to disperse, maintaining the proper operating temperature.

	Wall
50mm (2")	50mm (2")

50mm (2")

50mm (2")

Wall

50mm (2")

Figure 3-2. Ventilation Requirements for Enclosure Mounting
Other considerations and tips that can help improve your installation, avoid damage and	Other Considerations
prolong operating life:

•Keep the ambient temperature constant and below 35°C (95°F). Keep the display away from heating and/or air conditioning vents. Changes in temperature may cause drifts in the display circuitry, which may affect performance.

•Keep the PlasmaWall away from devices that radiate electromagnetic energy such as motors and transformers. Common sources of these include slide projectors, speakers, power amplifiers and elevators.

•Handle the unit carefully when installing or carrying it. Use the built-in handles; DO NOT touch or hold the screen face.

•Set the unit away from heat, excessive dust, and direct sunlight.

•Protect the inside of the unit from liquids and small metal objects. In case of accident, unplug the power cord and have it serviced by an authorized Service Center.

•Do not hit or scratch the panel surface as this causes flaws on the surface of the screen.

•For correct installation and mounting it is strongly recommended to use a trained, authorized dealer.

•To avoid sulfurization, it is strongly recommended not to place the unit in a dressing room in a public bath or hot spring bath.

Runco PlasmaWall Owner’s Operating Manual 19