Runco PL-50XA manual RS-232 Connection from the DHD Controller to the PlasmaWall

Installation

Digital Video Connection: The PlasmaWall has two HDMI inputs. Connect the DVI output from the DHD Controller to the DVD/HD3 input, using a DVI-to-HDMI cable.

RGB-HD Connection: Connect the RGBHV output from the DHD Controller to the PC/RGB input on the PlasmaWall. Use a VGA-to-RGBHV breakout cable with 5 BNC connectors on the DHD end and a standard, 15-pin, male VGA connector on the PlasmaWall end.

RS-232 (External Control) Connection: Connect the RS-232 output from the DHD Controller to the EXTERNAL CONTROL input on the PlasmaWall. Use a standard, modular telephone cable with RJ11 plugs at both ends. On the PlasmaWall end, use an RJ11-to-DB9, crossover adapter wired as shown in Figure 3-4.

4	XMT DATA		RCV DATA	2
3	RCV DATA		XMT DATA	3
	SIG GND		SIG GND
2, 5				5
			REQUEST TO SEND
To/From				7
DHD					6	1
Controller			CLEAR TO SEND	8	9	5
			DATA TERMINAL READY	4
			DATA SET READY
				6
1, 6		NO CONNECTION
				1, 9

DB-9 Female

RJ-11 Male

Figure 3-4. RS-232 Connection from the DHD Controller to the PlasmaWall

Runco PlasmaWall Owner’s Operating Manual 21