Runco PL-50XA manual Composite Video Input, RS-232 Control Port, Main AC Fuse, Main Power Switch

Controls and Functions

6.COMPOSITE VIDEO INPUT

Standard composite video input for connecting a VCR, camcorder, laser disc player or other composite video source.

7.S-VIDEO 1 / S-VIDEO 2

Two, standard S-Video inputs for connecting a DVD player, satellite receiver or Super VHS (S-VHS) VCR.

8.12-VOLT (800 mA) TRIGGER OUTPUTS

Connection for up to three (3), 12-volt trigger-controlled devices.

9.RS-232 OUTPUT (6-Wire, RJ-11 jack)

Connect this to the EXTERNAL CONTROL input of the PlasmaWall.

10.IR

Wired input from an external remote control or infrared receiver. It is a 3.5-mm, mini phono jack, wired as follows:

Ring = +5V Tip = IR Input Sleeve = Ground

When an external remote control or infrared receiver is connected

Note to the wired IR input, the IR sensor on the front of the DHD

Controller is disabled.

11.RS-232 CONTROL PORT

A female, 9-pin D-sub connector for interfacing with a PC or home theater automation/control system.

12.POWER INPUT (100 to 240 VAC) Connect the DHD Controller to power here.

13.MAIN AC FUSE

This is the main AC input fuse (5mm x 20mm, 500 mA, 250V slow-blow).

14.MAIN POWER SWITCH

Disconnects or applies power to the DHD Controller.

Runco PlasmaWall Owner’s Operating Manual 11