Xantrex Technology RC7, RC/GS owner manual 2RV Series Inverter/Charger Front Panel

Page 20

RC-GS_manual.book Page 8 Friday, May 20, 2005 4:57 PM

Installation

3.Run the cable between the remote and the RV Series Inverter/Charger.

4.Place the ON/OFF switch on the RV Series Inverter/ Charger to the OFF position and disconnect the AC power.

5.Connect the communications cable into the RJ11 port on the inverter/charger marked “Remote Control” (Figure 2-2).

Remote Control port

ON/OFF switch

Figure 2-2RV Series Inverter/Charger Front Panel

6.Connect the other end of the cable into the jack on the remote (Figure 2-3).

Remote cable jack

Figure 2-3RC/GS and RC7 Back View

7.Secure the remote to the wall or outlet box using the appropriate screws (4 required).

8	975-0210-01-01

Image 20

Contents RV Series Remote Control RC-GSmanual.book Page ii Friday, May 20, 2005 457 PM RV Series Remote Controls Date and Revision Organization Purpose ScopeAudience Conventions Used Related InformationImportant Safety Instructions General PrecautionsExplosive gas precautions Contents Operation Warranty and Return Information RC-GSmanual.book Page x Friday, May 20, 2005 457 PM Introduction Features 1RC/GS Front Panel2Remote Control Cable Types Indicators and Controls Installation Installing the RC/GS and RC7 Materials and tools requiredMounting and Connecting Choosing a location2RV Series Inverter/Charger Front Panel System Status AC Available RC-GSmanual.book Page 10 Friday, May 20, 2005 457 PM Configuration Viewing the Setup Menu Changing SettingsSet Idle Configuring the RC/GS and RC7Battery Capacity Battery Type Battery Capacity SettingsSet Shore Power Max Charge RateRemote Setup LCD ContrastSet Clock RC/GS Only Select Genset RC/GS OnlyGenerator Start RC/GS Only 11Select Genset menu itemsGenerator Stop RC/GS Only 13Generator Start/StopThermostat Start Enable and Disable RC/GS Only 15Generator Start/Stop on Generator Start menuBegin Gen Quiet and End Gen Quiet RC/GS Only 17Begin Generator Quiet Time displaySaving Setup Choices 19Setup/Menu Item ButtonsRC/GS and RC7 Setup Menu Summary RV Series Inverter/Charger and RC/GS and RC7 SetupAuto Gen Start Setup RC/GS Only Operation Status LEDs Status LEDsInverter LED Charge LEDBatt. Full LED Error LEDLCD Screen On/Off Meter ModeButtons System Status Displays AC Source MessagesWaiting for AC Genset Status Pending, Cranking and Restart RC/GS OnlyStarter Cooldown and Gen Start RC/GS Only Genset Status Starter CooldownGen Won’t Start Genset Error Messages RC/GS OnlyGen Quiet Fault 5Gen Quiet Fault Error Message Inverter Mode Messages System Status InvertingAbsorption Charging Charger Mode MessagesBulk Charging Float Charging Equalizing ChargingInverter/Charger Error Messages 12Equalizing ModeOver Temperature OverloadHigh Battery Voltage Low Battery VoltageCharger Fault Charger FaultAverage Shunt Amps Battery VoltageMeters Display AC Input Amps Inverter/Charger CurrentAC Output Voltage Battery State of Charge System Status MessagesSet Shore Power Generator Start/Stop RC/GS OnlyStorage Checklist Preparation for StorageRC/GS and RC7 User’s Menu Summary Generator Status Messages RC/GS OnlySystem Status Display VACRC-GSmanual.book Page 48 Friday, May 20, 2005 457 PM Warranty and Return Information WarrantyWarranty and Return Exclusions DisclaimerProduct Return Material Authorization Policy Return ProcedureOut of Warranty Service Information About Your System Serial Number Purchased From Purchase DateRC-GSmanual.book Page 55 Friday, May 20, 2005 457 PM Xantrex Technology Inc