Xantrex Technology RC7 Genset Error Messages RC/GS Only, Gen Won’t Start, Gen Quiet Fault

RC-GS_manual.book Page 32 Friday, May 20, 2005 4:57 PM

Operation

Genset Error Messages (RC/GS Only)

Gen Won’t Start

If the generator does not start after the three attempts, the RC/ GS displays the message “Gen won’t Start” and the red Error LED on the front panel lights. After displaying this message, the RC/GS automatically sets the Generator Start menu to “Manual (Push ON)” and no further attempts to start the generator will occur. Correct the starting problem and set the RC/GS back to the previous auto-start menu.

Inverter

Charge

Batt. Full

Error

Genset Status: ;

Gen wont Start

Buzzer sounds

822-4A-001

Red Error LED lights and error message appears in the screen

Figure 4-4Gen Won’t Start Error Message

Note: Press any arrow button to cancel the buzzer.

Gen Quiet Fault

If the generator has started in response to an auto start setting and is running when quiet time begins, it shuts down automatically. The buzzer also sounds and the screen shows the message “Gen Quiet Fault” and the red Error LED comes on. The remote control also emits a series of beeping sounds for up to five minutes (press any arrow button on the RC/GS to stop the alarm). If the auto-start condition still exists at the end of quiet time, the generator will start. The gen quiet period can be overridden by setting the Gen Quiet Begin and Gen Quiet End time to the same time.

32 975-0210-01-01