Xantrex Technology RC7, RC/GS owner manual Saving Setup Choices, 19Setup/Menu Item Buttons

Page 34

RC-GS_manual.book Page 22 Friday, May 20, 2005 4:57 PM

Configuration

Saving Setup Choices

Once the setup options are complete, press and hold the Setup/Menu Item buttons (see Figure 3-19) for approximately five seconds or until the screen clears. The setup choices will be saved in the inverter/charger’s non-volatile memory 20 seconds after exiting the Setup menu if no other actions are taken. These settings will be preserved until changed.

Note: The generator start and stop settings will not be saved if the RC/GS is disconnected or DC power is lost.

Menu Item

Meter Mode

Setup

Figure 3-19Setup/Menu Item Buttons

22	975-0210-01-01

Image 34

Contents RV Series Remote Control RC-GSmanual.book Page ii Friday, May 20, 2005 457 PM RV Series Remote Controls Date and Revision Audience Purpose ScopeOrganization Conventions Used Related InformationImportant Safety Instructions General PrecautionsExplosive gas precautions Contents Operation Warranty and Return Information RC-GSmanual.book Page x Friday, May 20, 2005 457 PM Introduction Features 1RC/GS Front Panel2Remote Control Cable Types Indicators and Controls Installation Installing the RC/GS and RC7 Materials and tools requiredMounting and Connecting Choosing a location2RV Series Inverter/Charger Front Panel System Status AC Available RC-GSmanual.book Page 10 Friday, May 20, 2005 457 PM Configuration Viewing the Setup Menu Changing SettingsBattery Capacity Configuring the RC/GS and RC7Set Idle Battery Type Battery Capacity SettingsSet Shore Power Max Charge RateRemote Setup LCD ContrastSet Clock RC/GS Only Select Genset RC/GS OnlyGenerator Start RC/GS Only 11Select Genset menu items Generator Stop RC/GS Only 13Generator Start/StopThermostat Start Enable and Disable RC/GS Only 15Generator Start/Stop on Generator Start menuBegin Gen Quiet and End Gen Quiet RC/GS Only 17Begin Generator Quiet Time displaySaving Setup Choices 19Setup/Menu Item ButtonsRC/GS and RC7 Setup Menu Summary RV Series Inverter/Charger and RC/GS and RC7 SetupAuto Gen Start Setup RC/GS Only Operation Status LEDs Status LEDsInverter LED Charge LEDLCD Screen Error LEDBatt. Full LED Buttons Meter ModeOn/Off Waiting for AC System Status DisplaysAC Source Messages Genset Status Pending, Cranking and Restart RC/GS OnlyStarter Cooldown and Gen Start RC/GS Only Genset Status Starter CooldownGen Quiet Fault Genset Error Messages RC/GS OnlyGen Won’t Start 5Gen Quiet Fault Error Message Inverter Mode Messages System Status InvertingBulk Charging Charger Mode MessagesAbsorption Charging Float Charging Equalizing ChargingInverter/Charger Error Messages 12Equalizing ModeOver Temperature OverloadHigh Battery Voltage Low Battery VoltageCharger Fault Charger FaultMeters Display Battery VoltageAverage Shunt Amps AC Output Voltage Inverter/Charger CurrentAC Input Amps Battery State of Charge System Status MessagesSet Shore Power Generator Start/Stop RC/GS OnlyStorage Checklist Preparation for StorageRC/GS and RC7 User’s Menu Summary Generator Status Messages RC/GS OnlySystem Status Display VACRC-GSmanual.book Page 48 Friday, May 20, 2005 457 PM Warranty and Return Information WarrantyWarranty and Return Product DisclaimerExclusions Return Material Authorization Policy Return ProcedureOut of Warranty Service Information About Your System Serial Number Purchased From Purchase DateRC-GSmanual.book Page 55 Friday, May 20, 2005 457 PM Xantrex Technology Inc