Xantrex Technology RC7, RC/GS owner manual Status LEDs

Page 38

RC-GS_manual.book Page 26 Friday, May 20, 2005 4:57 PM

Operation

Indicators and Controls

The RC/GS and RC7 feature LEDs, a display screen, and buttons for viewing operating status.

Status LEDs

Four indicator lights (LEDs) light up or flash during operation to indicate the system’s status. When the inverter is powered on, all LEDs flash as the unit goes through a self- test. After the self-test completes, the LEDs indicate the current state of the inverter and charger. Use these LEDs along with the screen to view complete system status.

Inverter

	Charge	Green
	Charge	Yellow
		Yellow
	Batt. Full	Yellow
	Batt. Full	Red
		Red
	Error

Figure 4-1 Status LEDs

26	975-0210-01-01

Image 38

Contents RV Series Remote Control RC-GSmanual.book Page ii Friday, May 20, 2005 457 PM RV Series Remote Controls Date and Revision Organization Purpose ScopeAudience Conventions Used Related InformationImportant Safety Instructions General PrecautionsExplosive gas precautions Contents Operation Warranty and Return Information RC-GSmanual.book Page x Friday, May 20, 2005 457 PM Introduction Features 1RC/GS Front Panel2Remote Control Cable Types Indicators and Controls Installation Installing the RC/GS and RC7 Materials and tools requiredMounting and Connecting Choosing a location2RV Series Inverter/Charger Front Panel System Status AC Available RC-GSmanual.book Page 10 Friday, May 20, 2005 457 PM Configuration Viewing the Setup Menu Changing SettingsSet Idle Configuring the RC/GS and RC7Battery Capacity Battery Type Battery Capacity SettingsSet Shore Power Max Charge RateRemote Setup LCD ContrastSet Clock RC/GS Only Select Genset RC/GS OnlyGenerator Start RC/GS Only 11Select Genset menu itemsGenerator Stop RC/GS Only 13Generator Start/StopThermostat Start Enable and Disable RC/GS Only 15Generator Start/Stop on Generator Start menuBegin Gen Quiet and End Gen Quiet RC/GS Only 17Begin Generator Quiet Time displaySaving Setup Choices 19Setup/Menu Item Buttons RC/GS and RC7 Setup Menu Summary RV Series Inverter/Charger and RC/GS and RC7 SetupAuto Gen Start Setup RC/GS Only Operation Status LEDs Status LEDsInverter LED Charge LEDBatt. Full LED Error LEDLCD Screen On/Off Meter ModeButtons Waiting for AC System Status DisplaysAC Source Messages Genset Status Pending, Cranking and Restart RC/GS OnlyStarter Cooldown and Gen Start RC/GS Only Genset Status Starter CooldownGen Won’t Start Genset Error Messages RC/GS OnlyGen Quiet Fault 5Gen Quiet Fault Error Message Inverter Mode Messages System Status InvertingAbsorption Charging Charger Mode MessagesBulk Charging Float Charging Equalizing ChargingInverter/Charger Error Messages 12Equalizing ModeOver Temperature OverloadHigh Battery Voltage Low Battery VoltageCharger Fault Charger FaultAverage Shunt Amps Battery VoltageMeters Display AC Input Amps Inverter/Charger CurrentAC Output Voltage Battery State of Charge System Status MessagesSet Shore Power Generator Start/Stop RC/GS OnlyStorage Checklist Preparation for StorageRC/GS and RC7 User’s Menu Summary Generator Status Messages RC/GS OnlySystem Status Display VACRC-GSmanual.book Page 48 Friday, May 20, 2005 457 PM Warranty and Return Information WarrantyWarranty and Return Exclusions DisclaimerProduct Return Material Authorization Policy Return ProcedureOut of Warranty Service Information About Your System Serial Number Purchased From Purchase DateRC-GSmanual.book Page 55 Friday, May 20, 2005 457 PM Xantrex Technology Inc