Zenith H20J55DT warranty Clone Programmer/Cloning Procedure Troubleshooting, Master and Other TVs

LT2002 Clone Programmer

Clone Operation Notes

Disconnect the Clone from the TV when you are finished; automatically switching it off. The real- time clock continues to run after the main circuits are switched off.

Reset Clone After Static Shock

After replacing exhausted batteries, or if the pro- grammer behaves strangely after a static shock, use a paper clip or similar instrument inserted through the small hole marked ”RESET” to activate the internal reset switch and restore normal opera- tion.

After a reset, check the real-time clock setting. It may be necessary to reset the Clone Programmer clock from a TV containing the correct time.

The LT2002 programmer is designed to be used with TV's containing the 221-01006 and later processors. Use with earlier TV sets may give unpredictable results. The specific microprocessor used in any TV set may be determined by activat- ing the Installer Menu. The microprocessor part number appears on the screen when the Installer Menu is activated. Processors before the 221- 01006-04 have a limited screen display capability. They can not display entire screens as shown in the quick setup instructions accompanying the LT2002 clone programmer. Use the printed menu illustrations on the quick setup sheet supplied with the Clone as an aid to making your programming choices. ( Although the menus are not all dis- played, the clone functions all operate normally).

Clone Programmer/Cloning Procedure Troubleshooting

Problem	Possible Cause(s)	Possible Solution(s)
Clone Programmer
LED does not blink.	• M.P.I. cord not connected.	- Connect M.P.I. cord.
	• TV not turned On.	- TV must be On for clone to work.
	• Weak batteries.	- Install 4 fresh AA high-quality alkaline
		batteries.
Clone menu hard	• Weak signal.	- Connect TV to a reliable signal Source.
to read.
No time set.	• No time on Master TV.	- Set time on master TV, copy time to Clone
		Programmer.
Menu items 7-8 not	• Not necessary.	- Channel Labels already cloned; if they were
on clone selection menu.		on Master TV.
Master and Other TV's
Cloning did not work.	• Procedure interrupted.	- Wait until procedure complete message is
		displayed.
	• Different TV models.	- Cloning is only possible with identical model
		Zenith TV's.
Clone time disappeared.	• Batteries were removed.	- Batteries must remain installed to retain time
		settings.
New Setup not present.	• TV not reset.	- Disconnect newly-cloned TV from power for
		15 seconds.
Digital information not	• 2-5-5 + Menu not done.	- Redo setup and 2-5-5 + Menu as required.
present.

When cloning operations are complete, just unplug the LT2000 from the TV.

If the TV does not display a picture (blank screen) after a few seconds, just change channels.

206-4065 Page 55