Hook Up Cable Service (CATV)
Connect cable service to the TV
Cable Service
1Locate the RF jack on the back of the TV set.
2Connect the CATV cable that runs from the wall to the
Antenna/Cable RF jack as shown to the right.
Typical
TV Back
Cable TV
Wall Jack
Antenna
Cable
| TV SPEAKER |
RF Coaxial Wire |
|
(75 ohm) |
|
M.P.I. | VIDEO IN SPEAKER OUT |
| PILLOW SPEAKER |
| AUDIO IN |
Cable Service with a Cable Box
1Locate the Antenna/Cable in jack on the back of the TV set.
2Connect the CATV cable that runs from the wall to the cable box
and TV according to the connec- tion diagram shown to the right.
If you’re using a cable box, tune the TV to channel 3 or 4 and use your cable box to change channels.
If you’re using a cable box, Auto Program might only find the channel your cable service is on (usually channel 3 or 4).
Cable TV
Wall Jack
In | Cable Box |
Out 
output 
switch 3 4
RF Coaxial Wire (75 ohm)
Typical
TV Back
Antenna
Cable
| TV SPEAKER |
M.P.I. | VIDEO IN SPEAKER OUT |
| PILLOW SPEAKER |
AUDIO IN
Page 9 |