Radio Shack Kameleon 4-in-One Changing Volume Lock, Unlock, Programming Favorite Channel Scan

RS 4in1 Kam User Manual.fm Page 10 Friday, March 4, 2005 9:09 AM

4-IN-ONE REMOTE POWERED BY KAMELEON

6.To check for codes of other devices, repeat steps 1 to 5, but substitute the appropriate device key for each device you are checking. Write down the device’s code digits in the appropriate code boxes on page 8.

CHANGING VOLUME LOCK

The RadioShack 4-in-One Remote is set at the factory for independent volume control of each selected device.

However, you may change the Volume Lock setting to Global Volume Lock so that a device’s volume will be locked to one mode (e.g., to control TV volume in all other modes). After that, if desired, you can perform Individual Volume Unlock on a selected device to set its volume control for independent operation.

LOCKING VOLUME CONTROL TO ONE MODE (GLOBAL VOLUME LOCK)

3.Enter 9 9 3 then press VOL-. The IR segment blinks four times.

4.Repeat steps 1 to 3 for any other device that you want to have independent volume control.

Now, after you select a device that has volume unlocked, pressing VOL-, VOL+, or MUTE will control the device’s volume only in its own mode.

UNLOCKING ALL VOLUME CONTROL (RESTORING DEFAULT SETTING)

1.Press and hold P until the red LED blinks twice, then release.

2.Enter 9 9 3 and then press VOL+. The IR Segment blinks four times. Volume is independently controlled for all programmed devices.

Volume will again be independently controlled according to its default states for all programmed devices.

1.Press and hold P until the IR segment flashes twice.

2.Enter 9 9 3 and then press the mode key for the device you want to control volume (for example, TV). The IR segment blinks twice.

Now, when you press VOL-, VOL+, or MUTE, the selected device’s volume will be controlled, regardless of the mode selected.

UNLOCKING VOLUME CONTROL FOR A

SINGLE DEVICE (INDIVIDUAL VOLUME

UNLOCK)

1.Press a device key (i.e., VCR, TV, CBL/SAT, or DVD) where you want the volume controls unlocked.

2.Press and hold P until the IR segment flashes twice.

PROGRAMMING FAVORITE CHANNEL SCAN

In all modes, the RadioShack 4-in-One Remote can store a list of up to 10 favorite channels, in any order, that will be immediately scanned when FAV SCAN is pressed (see “Using Channel Scan” on page 11).

NOTE: Favorite channels can only be programmed for one mode. After programming, if FAV SCAN is pressed while in another mode, the remote control will start a normal channel scan instead (if applicable to the selected device).

1.Select a Favorite Channel Mode by pressing VCR, DVD, CBL/SAT, or TV. The IR segment flashes once as the selected device key animates.

10 Changing Volume Lock