Radio Shack Kameleon 4-in-One owner manual Using Channel Scan, Reassigning Device Keys

RS 4in1 Kam User Manual.fm Page 11 Friday, March 4, 2005 9:09 AM

2.Press and hold P until the IR segment flashes twice.

3.Using the number keys, enter 9 9 6. The IR segment will flash twice.

NOTE: If the IR segment displays one long flash, an error has occurred. Try repeating this step.

4.Using the number keys, enter a favorite channel number (e.g., 0 1 2). Then press P. The IR segment will flash three times confirming your entry.

NOTE: If the original remote control

required pressing an ENTER key to change the channel, also press the ENTER key after the channel number (e.g., 0 1 2 ENTER).

NOTE: If you try entering more than 10 channels, or if more than 10 seconds elapse between key presses, the remote automatically exits programming.

5.If desired, repeat step 4 for each channel to be stored, up to a total of 10 channels.

NOTE: After storing 10 channels, the

remote control will exit Favorite Channel programming.

6.To exit programming with less than 10 favorite channels stored, press and hold P until the IR segment flashes twice.

NOTE: If you have entered less than 10 favorite channels and wish to add more, you will need to re-enter all of the channels.

NOTE: If you have programmed 10 favorite channels, you will need to reset the remote to program new channels. See “Troubleshooting” on page 14.

OWNER’S MANUAL

USING CHANNEL SCAN

In all modes, press the SCAN key to start a 3- second scan of all channels. If programmed, press the FAV SCAN key to scan only your favorite channels to view a desired channel (see “Programming Favorite Channel Scan” on page 10).

1.Press VCR, DVD, CBL/SAT, or TV. The IR segment flashes once as the selected device key animates.

2.Press FAV SCAN. The IR segments will display outgoing animation as each channel is changed.

•If Favorite Channel Scan has been set up, scanning of favorite channels will start and cycle through stored channels for 3minutes or until stopped by pressing any key.

•If Favorite Channel Scan has not been set up, scanning will start with the current channel, then proceed to the next channel up and cycle through all channels for 3 minutes or until stopped by pressing any key.

3.To stop scanning channels at any time, press any key.

REASSIGNING DEVICE KEYS

The RadioShack 4-in-One Remote can be set to control a second device. For example, to control a TV, a cable box, and two DVD players, you can reassign an unused VCR key to operate the second DVD player as follows:

1.Press and hold P until the IR segment flashes twice.

2.Using the number keys, press 9 9 2. The IR segment flashes twice.

Using Channel Scan 11