Speco Technologies D8RS, D16RS, D4RS manual Setup Device Mode

4-4. Setup – DEVICE Mode

In the SETUP menu, select the DEVICE tab. Then, the device menu is displayed as pictured below. Navigate through the menu items using the mouse or the control button on the remote control and change the value of the menu item.

	Figure 4.4.1. DEVICE Setup Screen
	Table 4.4.1. Menu Items in DEVICE Setup Screen
Item	Description
ALARM OUT	Set the sensor, motion, and video loss for triggering alarm relay
	HDD Error and Video Loss can trigger beeping.
	(D4RS does not support ALARM OUT.)
CONTROLLER &	Set the PTZ baud rate, protocol, and ID.
PTZ	(D4RS does not support CONTROLLER & PTZ.)
SPOT-OUT	D4RS/D4WRS: CVBS OUT is switchable as Composite Video Output
	or Spot-Out according to the resolution of VIDEO OUTPUT (VGA).
	D8RS/D16RS/D8WRS/D16WRS: CVBS1 – Composite Video Output /
	CVBS2 – Spot-Out.
SITE	Select specified channel for motion zone setup.
MOTION ZONE	Select either Full Zone or Partial Zone for motion detection.
MOTION	Set the motion sensitivity for the selected channel.

26