Speco Technologies D8RS, D16RS, D4RS manual Spot Out

Note: Connect PTZ cameras that support RS-485 directly to the RS-485 port. If the camera is controlled through an RS-232C interface, use an RS-232C to RS-485 to RS-232C signal converter.

Use the PTZ setup screen to select the following options for the camera PTZ controller:

-CHANNEL: Channel connected to a PTZ device

-CAMERA: Protocol Type

-SPEED: 19200, 14400, 9600, 4800, 2400 (Baud rate)

-ID: 0-63

Controller (Keyboard Controller): If a PTZ controller is used, select a controller protocol from Controller menu. Set SPEED (Baud Rate) and ID number.

4-4-3. Spot Out

	Figure 4.4.6. SPOT-OUT Setup Screen
	Table 4.4.4. Menu Item in SPOT-OUT Setup Screen
Item	Description
SPOT OUT	Only 1 Spot Out is available to use.
	To use the Spot out function on D4RS, Video Resolution has to be
	setup as 1280x1024 (Video Resolution Output can be setup on
	DISPLAY MENU.)
SPOT TYPE	SPOT 1 supports only FULL type. (1 channel only)
SPOT ON EVENT	Enable/disable channel change if an event occurs on a channel.
SPOT EVENT	Set the dwell time for the display of the event activated channel.
DWELL TIME	(1-10sec)
SEQUENCE	Enable/disable sequential display of spot channel in full screen.
	If select ON, the selected channel will be displayed on the monitor
	periodically.
SEQUENCE	Set the dwell time for the spot channel display.(1-10sec)
DWELL TIME
SPOT CHANNEL	Select a channel for spot monitoring using the mouse or the control
	button on the remote control and press OK button.
	29