Palsonic HDSTB100 owner manual Connecting to a HD monitor YPbPr type, Rear of HD Ready TV

Page 12

Chapter 3: Getting Started

Connection

 

 

Connecting to a HD monitor (YPbPr type)

Follow this diagram when connecting.

Antenna

Rear of STB

RS232

YPbPr

RGB

Rear of HD Ready TV

Note:

The YPbPr/RGB selection switch must be set to YPbPr.

The component out jacks are available when HD1 (576p), HD2 (1080i), or HD3 (720p) display format is selected.

Important

After you toggle the Display Format Selection Switch, you must turn off the STB and then turn on again, then the toggling can effect.

10

Image 12
Contents N111 Table of Contents Connect AC Power Cord Connecting to MonitorConnecting to a Secondary Display or VCR Connecting to an AmplifierSafety Instructions Introduction Front ViewBack View Front and rear view of the STBRemote control function key list ListMIX Remote control functional key list ExitLetterbox Aspect Sidebar Aspect16 PIP/VCR PIP control buttonsProgram System Password Time Menu OverviewMain Menu Connecting to Antenna Getting StartedAntenna Rear of STB Rear of TVConnecting to an Analog monitor Display Formats OverviewConnecting to a HD monitor YPbPr type Rear of HD Ready TVConnecting to a HD monitor RGB type Connecting to a VCR Rear of VCR Connecting to an AmplifierFollow this diagram when connecting AmplifierOperations Quick SearchAuto Search Program SearchChannel and Program Selection Making use of Program List to select programSpeProgram Search/Channel & Program selection Channel Banner Audio Setup Default SetupAudio Setup/Default Setting Stereo OutputPassword setup Clear passwordLock Settings When you have not set a password yetLock Settings/Time Zone Selection Appendix DTV Channel TableTroubleshooting Specifications RGB604-DHT923-00