Chapter 2: Introduction | Remote control function key list |
|
|
Remote control battery installation
Detach the battery cover on the rear of the remote control, and insert two size AAA batteries in correct polarity.
Caution
Do not mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.).
Remote Control Operation Range
Point the remote control at the remote sensor and press the buttons.
Distance: About 5 m from the front of the remote sensor.
Angle: About 300 in each direction of the front of the remote sensor.
You can operate every function of this STB using the buttons on the remote control handset. Below is the remote control functional key list.
Press to turn ON and OFF (in standby).
Press to mute the sound. Press again to restore.
Press numeric keypad to select any channel.
0 ~ 9 In menu operation, used to enter numerical values wherever required, e.g. to enter a password.
You can quickly check the status of current display DSP program by pressing the DSP button.
Press DSP button twice to display EPG information if available.
You can choose different audio outputs in Audio Setup menu. The STB includes standard audio mode options such as stereo or mono sound to match the broadcast signal or your home entertainment stereo
AUDIO system. Other audio mode options may be supported by your service provider or TV broadcaster, such as selecting alternate languages, or different commentators for sport events.
Press AUDIO button, then make use of menu navigation button (
,
) and ENTER button to select.
VOLUME +/- Press to increase or decrease the volume.
PROGRAM+/- Select next/previous programs.
LIST | When you are watching TV channels, you can press | |
LIST button to call up the Program List. | ||
| ||
MIX | Press to conceal or reveal main picture and (or) PIP | |
| when viewing teletext. |
TELETEXTPress to display teletext on the screen if available.
Note: normally it will display teletext index page P100 when pressing TTX button. If TV station does not broadcast teletext information but caption, the unit will switch to Page 801 to display Caption after 15 seconds.
If you are sure that there is no index page, you can directly enter into page 801 to save time. Whether there is index page or not, you can consult local station.
4