Palsonic HDSTB100 owner manual Connecting to a HD monitor RGB type

Page 13

Chapter 3: Getting Started

Connection

 

 

Connecting to a HD monitor (RGB type)

Follow this diagram when connecting.

Antenna

Rear of STB

RS232

YPbPr

RGB

Rear of HD Ready TV

Note:

The YPbPr/RGB selection switch must be set to RGB.

The RGB out jack is available when HD1 (576p), HD2 (1080i), or HD3 (720p) display format is selected.

Important

After you toggle the Display Format Selection Switch, you must turn off the STB and then turn on again, then the toggling can effect.

11

Image 13
Contents N111 Table of Contents Connecting to Monitor Connect AC Power CordConnecting to a Secondary Display or VCR Connecting to an AmplifierSafety Instructions Front View IntroductionBack View Front and rear view of the STBList Remote control function key listMIX Exit Remote control functional key listLetterbox Aspect Sidebar AspectPIP control buttons 16 PIP/VCRMenu Overview Program System Password TimeMain Menu Getting Started Connecting to AntennaAntenna Rear of STB Rear of TVDisplay Formats Overview Connecting to an Analog monitorRear of HD Ready TV Connecting to a HD monitor YPbPr typeConnecting to a HD monitor RGB type Rear of VCR Connecting to an Amplifier Connecting to a VCRFollow this diagram when connecting AmplifierQuick Search OperationsAuto Search Program SearchMaking use of Program List to select program Channel and Program SelectionSpeProgram Search/Channel & Program selection Channel Banner Default Setup Audio SetupAudio Setup/Default Setting Stereo OutputClear password Password setupLock Settings When you have not set a password yetLock Settings/Time Zone Selection DTV Channel Table AppendixTroubleshooting RGB Specifications604-DHT923-00