Palsonic HDSTB100 owner manual Connect AC Power Cord, Antenna Connection, Connecting to Monitor

SET-UP AND QUICK USE GUIDE

Step 1: Connect AC Power Cord

Plug the AC power cord into the AC outlet. Do not turn on any devices until you

have finished making all necessary connections.

Step 2: Antenna Connection

Connect the antenna cable to the RF IN jack on the rear panel of the STB (For details, please refer to page 8).

Step 3: Connecting to Monitor

A.If your monitor is an Analog Monitor, please follow the diagram and notes in page 9 when connecting the STB to your monitor.

B.If your monitor is a HD Monitor (YPbPr type), please follow the diagram

and notes in page 10 when connecting the STB to your monitor.

C. If your monitor is a HD Monitor (RGB type), please follow the diagram and notes in page 11 when connecting the STB to your monitor.

Step 4: Connecting to a Secondary Display or VCR

Please follow the diagram and notes in page 12 when connecting the STB to the Secondary Display or VCR.

Step 5: Connecting to an Amplifier

Please follow the diagram and notes in page 12 when connecting the STB to the Amplifier.

Step 6: Turning STB On

Press the Power Switch on the STB to turn on the STB.

Note: Monitor should also be turned on.

Step 7: Setting Time Zone

To obtain local time, you should first set local time zone. For further details, please refer to page 18.

1