appropriate. Also, either module can be removed should servicing be required.
Caution: Observe electrostatic discharge precautions when installing or removing the Module(s) from the Chassis. Failure to observe this caution could result in damage to the Module(s) and/or chassis.
1.Loosen the Captive retainer screw on the front of the module.
2.Gently pull the module towards you.
3.Set any jumpers and/or DIP switches on the Module to the desired operating mode. (Refer to the product guides that came with your SMI Media Converter).
4.Gently slide the module back into the slot until it becomes flush with the front of the chassis. Light pressure may be needed to seat the module. Do not force the module as you might damage the module. If there is resistance, remove the module and check the module’s backplane connector for damage to the pins. If the module’s backplane connector is not damaged, try to reinsert the module again
5.Tighten the Captive retainer screw to ensure the module is locked in place.