ENGLISH
•In the rare event that NG appears on the LCD, it means that the remote controller you are attempting to learn from uses special signals that cannot be learned by the Marantz remote controller.
6.Follow the same procedure to make the remote controller learn the
7.Repeat the procedure from step 3 to have the remote controller learn the signal codes for the other components such as TV, VCR, etc.
• I f n o b u t t o n s a r e p r e s s e d f o r approximately 1 minute while in the LEARN mode, the remote controller automatically returns to the USE mode.
•When programming the function buttons, first switch to the desired function, then press the button again.
8.When you have finished programming the remote controller, use a ballpoint pen or other sharp point to once again press the MODE button z to return it to the USE mode. The LCD displays the USE indicator, and the newly programmed codes now can be used.
If FULL is displayed on the LCD
If FULL is displayed on the LCD B when programming in the LEARN mode, it means that the memory has become too full to hold any further codes.
If FULL is displayed no matter how many times you attempt to enter new codes, it means that the remote controller cannot accept any new codes until some of the previously learned codes are deleted to make space in the memory. Select unneeded codes for each of the Jog Dial control m and Function buttons ,, which show FULL and delete them from the memory.
12