ENGLISH
OTHER FUNCTIONS
LIGHTING BUTTON
To allow easy use in a location which has been darkened for a home theater performance, for instance, this remote controller has an LCD display which lights up. It lights up when the LIGHTING button ⁄9or any other button is pressed. While the LIGHTING button ⁄9is pressed, it lights, and when it is released, it goes off.
•Signals can be sent even while the LIGHTING button is held down.
•The display can be set to light for a duration of 0 to 10 seconds.
Note:
•When the lighting duration is set to 0,
the LCD display will light up only while the LIGHTING button ⁄9is held down and for 5 seconds after the button is released.
LUMINOUS BUTTONS
The buttons on this remote controller are designed to remain luminous in dim lighting conditions. If the buttons are no longer luminous when the remote controller is used in low light, recharge them by placing it near a fluorescent or other light source for a sufficient amount of time. This should return the buttons to their luminous condition.
SETUP
Switch the
1.While pressing the MEMO button ⁄6, press the OK Cursor button ⁄0. This will switch the remote controller to the Setup mode.
(Wait 3 seconds.)
w | CH | OK |
| VOL |
|
|
|
| |
| C D | DVD | ||
| DSS | T V | VCR | AUX |
| L D | TUNER | TAPE | AMP |
q | CLEAR | MEMO | GUIDE MUTE | |
| AUTO | DOLBY THX | DTS | HALL |
1 2 3 4 5
36