Front AV Inputs using the Remote control, Control

OWNER’S MANUAL/INSTALLATION GUIDE
DESCRIPTION OF REAR CONNECTORS	2 (Front AV Inputs) using the Remote control.
	4 STEREO IN L/R LINE-1 (RCA Jacks)
	Use a stereo RCA audio cable to connect stereo audio from an
	alternate A/V source. You can choose either audio source
	LINE 1 or LINE 2 (Front A/V Inputs) using the Remote
	control.
	5 DC IN 12V (4-Pin Molex)
	Use the supplied DC power cord to connect the VDH910
	to the vehicle’s 12-volt electrical system.
Figure 1. The VDH910’s rear connections.	6 REMOTE SENSOR INPUT (3.5 mm Plug)
1 STEREO L/R OUTPUT (RCA Jacks)	Install and connect the remote mount IR Sensor (included)
Use a stereo RCA audio cable to connect stereo audio from	to the back of the VDH910 when the player is hidden
the VDH910.	away or mounted under a seat.
2 VIDEO OUT (RCA Jack)	7 RF INPUT (F-Connector)
Use an RCA video cable to connect video from the	Use with a 75 ohm antenna.
VDH910 to the Monitor.	8 RF OUTPUT (F-Connector)
	8 RF OUTPUT (F-Connector)
3 VIDEO IN LINE-1 (RCA Jack)	Route to 75 ohm TV input.
Use an RCA video cable to connect a video input signal
to the VDH910. You can choose either LINE 1 or LINE

2 (Front AV Inputs) using the Remote control.