Clarion owner manual VDH910 can be mounted horizontally or vertically, as, Shown in Figures 15

Page 19

OWNER’S MANUAL/INSTALLATION GUIDE

INSTALLATION AND WIRING

Installing The VDH910

The VDH910 can be mounted horizontally or vertically, as

shown in Figures 15 and 16.

NOTE: For best results, Clarion recommends horizontal mounting, since vertical mounting may produce increased picture jitter while the vehicle is moving.

Figure 15. Vertical mounting of VDH910.

Figure 16. Horizontal mounting of VDH910.

Image 19

Contents VDH910 Page About Installation Wear and tape cleaning requirements Use a dry cloth when dusting your VCR Videocassette Use DC in 12V 4-Pin Molex Front AV Inputs using the Remote controlStereo in L/R LINE-1 RCA Jacks Control4 5 7 9 q w e r t Play Button Press button to play the videocassette FF Button VDH910’s Remote Control Battery Installation for the VDH910’s Remote Control Button to increase or CH/TRK DN button to decrease Videocassette in the Cassette CompartmentRecord Speed SP or SLP Antenna/Cable display for On-Screen programming Channel Add/Delete for On-Screen programming Supplied IR Sensor for the VDH910 REW, PLAY, and FF on the VDH910 Remote Control To cancel FF or REW, press Play or the Stop buttonRecording from the TV tuner Shown in Figures 15 VDH910 can be mounted horizontally or vertically, asWiring diagram for VDH910 Into unit Video heads Clean unit see Are dirtySounds mono Audio Output To change audio Mode Videocassette Another tape Does not insertFormat Page Clarion Corporation of America